Does anyone know the exact measurement from the mounting on the rear rotor to the shock? I'm looking to get as muck back spacing as possible. I'm mot worried about the offset measurement, only the measurements from mounting surface to the shock.
Does anyone know the exact measurement from the mounting on the rear rotor to the shock? I'm looking to get as muck back spacing as possible. I'm mot worried about the offset measurement, only the measurements from mounting surface to the shock.
SEMPER FI From York, Pa
Anyone have their car on a lift who can let me know?
SEMPER FI From York, Pa
you can add 2" to the factory wheel but you will have to make sure the tire section width is the same or less than that of the wheel. sorry i don't know what that comes out to on the backspace by adding the 2" to the stock wheel.
~Chris
Thank you, but I"m looking for the actual physical measurement from the wheel mounting surface, on the rotor hat, to the outer edge of the shock. I would think the measurement will be between 10 and 11 inches.
SEMPER FI From York, Pa
There are currently 1 users browsing this thread. (0 members and 1 guests)