2003 Vin # 2MEHM475V03X668390
I replaced the control module for the fan in the A/C duct under the hood. The fan still does not come on. Everything works normally. The fan was intermittent before the module replacement. If I get on the freeway with air coming into the system from outside I get heat and cold through the vents floor and defroster. Any ideas?
At this point Im thinking the fan motor.
Everything Marauder, LEDs & HI
Try tapping the BCM that you just replaced.Originally Posted by Flbatfish
Where did you get the BCM from?
The air not coming out of the vents means the o-rings in the EATC need to be replaced.
I can fix the EATC for you and supply a repaired BCM.
PM me.
“When you can’t make them see the light, make them feel the heat.”
Ronald Regan
"The only way to deal with the Islamic State - these blood thirsty, blood-drunken, terrorists -
is to kill them, keep on killing them, until you kill the last one, then you kill his pet goat."
Lt. Colonel Ralph Peters
“Be polite, be professional, but have a plan to kill everybody you meet.”
"I come in peace. I didn't bring artillery. But I'm pleading with you, with tears in my eyes, if you **** with me, I'll kill you all"
General James Mattis
2003 Vin # 2MEHM475V03X668390
The part was from auto-zone
Everything Marauder, LEDs & HI
Some aftermarket parts aren't that good. Might want to try and return it for a new one.
“When you can’t make them see the light, make them feel the heat.”
Ronald Regan
"The only way to deal with the Islamic State - these blood thirsty, blood-drunken, terrorists -
is to kill them, keep on killing them, until you kill the last one, then you kill his pet goat."
Lt. Colonel Ralph Peters
“Be polite, be professional, but have a plan to kill everybody you meet.”
"I come in peace. I didn't bring artillery. But I'm pleading with you, with tears in my eyes, if you **** with me, I'll kill you all"
General James Mattis
73 is the best number.
Jim, I believe he said air does come from the vents, just that the fan isn't blowing.
The Blackbird
Trilogy #61
Driveway Queen
The Spruce Goose
2004 Grand Marquis LS Limited Edition
Daily Driver
Everything Marauder, LEDs & HI
You sir are correct!
“When you can’t make them see the light, make them feel the heat.”
Ronald Regan
"The only way to deal with the Islamic State - these blood thirsty, blood-drunken, terrorists -
is to kill them, keep on killing them, until you kill the last one, then you kill his pet goat."
Lt. Colonel Ralph Peters
“Be polite, be professional, but have a plan to kill everybody you meet.”
"I come in peace. I didn't bring artillery. But I'm pleading with you, with tears in my eyes, if you **** with me, I'll kill you all"
General James Mattis
wanna be
You can jump the blower motor to make sure it's operating just unplug at the motor and put 12v to it
04 mgm (rauder wannabe)
Jmod, 2900 stall 10inch. Pi shaft and housing with lube mod. 3.73 carbon posi. 70mm tb ported knives edged plate and modded shaft, plenum p and p. Boc tune. And the mods don't stop.
2003 Vin # 2MEHM475V03X668390
Update I went to the Relay that is in the box under the hood behind the battery. Removed the blower relay took a tooth brush to the contacts and replaced it. The blower has worked normally so far.
Senior Member
I'd replace the relay as the points burn in time......
My A/C clutch relay became intermittent for the same reason!!
No Marauder
Everything Marauder, LEDs & HI
Might be a good idea to replace all the relays in the power distribution box.
“When you can’t make them see the light, make them feel the heat.”
Ronald Regan
"The only way to deal with the Islamic State - these blood thirsty, blood-drunken, terrorists -
is to kill them, keep on killing them, until you kill the last one, then you kill his pet goat."
Lt. Colonel Ralph Peters
“Be polite, be professional, but have a plan to kill everybody you meet.”
"I come in peace. I didn't bring artillery. But I'm pleading with you, with tears in my eyes, if you **** with me, I'll kill you all"
General James Mattis
Senior Member
^^^^+1^^^^
No Marauder
2003 Vin # 2MEHM475V03X668390
Update after chasing this for weeks I came up with the problem. The connecter for the Fan Motor was not completely plugged in.
When I started the can the motor did not come on I was able to lift the hood with out it starting running. Normally any bump would start the motor running. I pushed in on the motor plug it clicked and the motor started running. I pushed and pulled on the plug and wires and everything remained normal. Its been 5 days and the motor is working flawlessly.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote
