Does anyone make...

[CKMustangCobra]

adapter plates for Infinity component speakers so they bolt in the factory location??? or do I have to make these myself?

[Pops]

adapter plates for Infinity component speakers so they bolt in the factory location??? or do I have to make these myself?

We take a piece of ABS plastic and trace the old speaker on it. Then you can cut out what you need. A Dremel tool with 1/8 drill but cuts it great.

John

[SILVERSURFER03]

well that about sums that up

[Pops]

well that about sums that up

[ctrlraven]

You can use ABS plastic or MDF. I opted for MDF to use with my 5.25" component system. Here is the woofer mounted in the factory speaker location with the adapter plate.

[CKMustangCobra]

I am thinking of putting the tweeter and woofer on the adapter plate... not even sure if it will fit.

Friend of mine suggested Infinity over the Pioneer 3 ways I was originally going with. If it doesn't fit I'll be researching infinity 2way/3ways vs pioneers.

[illwood]

I am thinking of putting the tweeter and woofer on the adapter plate... not even sure if it will fit.

Friend of mine suggested Infinity over the Pioneer 3 ways I was originally going with. If it doesn't fit I'll be researching infinity 2way/3ways vs pioneers.

That is a decent plan for components on the rear deck, but I think that you would want a closer location for the tweeters in the front. Personally I am planning on making some custom sail panels so the tweeters will be right by the a-pillar.