Register
Help
Remember Me?
What's New?
Activity Stream
New Events
New Articles
New Blog Entries
Mark Forums Read
Articles
Forum
Blogs
Paid Subscriptions
Advanced Search
Home
Activity Stream
If this is your first visit, be sure to check out the
FAQ
by clicking the link above. You may have to
register
before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Activity Stream
Filter
Sort By
Time
Show
Recent
Recent
Popular
Popular
Anytime
Anytime
Last 24 Hours
Last 24 Hours
Last 7 Days
Last 7 Days
Last 30 Days
Last 30 Days
All
All
Photos
Photos
Forum
Forums
Articles
Articles
Blog
Blogs
New Activity (
)
Please reload this page to view the 200+ new activity items that have been created.
Older Activity
04-24-2024,
09:17 PM
SilverPhoenix
replied to a thread
Replaced air ride pump, right side lower than left.
in
Shop Talk
Just replaced the air bags on mine last week (185,xxx). Compressor isn't making any weird noises...yet. When I think it is, it usually turns out to...
see more
12 replies | 1588 view(s)
04-24-2024,
07:21 PM
crouse
replied to a thread
Axle Seal Replacement
in
Shop Talk
Thanks. In the video link I posted, the guy has a good technique for putting them back in.
see more
10 replies | 200 view(s)
04-24-2024,
07:19 PM
crouse
replied to a thread
Axle Seal Replacement
in
Shop Talk
Good advise. Thanks.
see more
10 replies | 200 view(s)
04-24-2024,
04:48 PM
Turbov6Bryan
replied to a thread
Axle Seal Replacement
in
Shop Talk
Don’t spin the axle when the pins removed, you will spit the spider gears out. id just rtv the cover, not the bearings or axle seal
see more
10 replies | 200 view(s)
04-24-2024,
04:44 PM
Turbov6Bryan
replied to a thread
Replaced air ride pump, right side lower than left.
in
Shop Talk
UPDATE : FIXED! Cars air ride was working perfectly, but my dad wanted the air ride pump replaced since the 20 year old one was making noise. ...
see more
12 replies | 1588 view(s)
04-24-2024,
02:01 PM
Cobra25
replied to a thread
Sunday April.28,2024 * Car & Truck Show * Pembroke Pines Fl.
in
Sunshine State Marauders
I plan on going and will be taking my Super Charged Custom Built Marauder .
see more
1 replies | 28 view(s)
04-24-2024,
02:00 PM
TORINO
replied to a thread
Axle Seal Replacement
in
Shop Talk
Be sure the vent is not plugged.
see more
10 replies | 200 view(s)
04-24-2024,
01:59 PM
Cobra25
started a thread
Sunday April.28,2024 * Car & Truck Show * Pembroke Pines Fl.
in
Sunshine State Marauders
:welcome1: This Sunday April 28th The Road Kings of Hollywood will be Hosting a Car & Truck Show. It will be Held at ***Fridays 90 North University...
see more
1 replies | 28 view(s)
04-24-2024,
12:56 PM
RubberCtyRauder
replied to a thread
Progress on build
in
Shop Talk
Mo's completed it and shipped it years ago
see more
265 replies | 55144 view(s)
04-24-2024,
12:56 PM
RubberCtyRauder
replied to a thread
Let me know if this is a dumb idea...
in
Community Discussion
Max towing is 1500 lbs.
see more
1 replies | 52 view(s)
04-24-2024,
11:09 AM
SilverPhoenix
started a thread
Let me know if this is a dumb idea...
in
Community Discussion
Towing an 18ft/3000lb camper trailer with the Marauder. Let me have it...
see more
1 replies | 52 view(s)
04-23-2024,
04:04 PM
1Marauder
replied to a thread
Progress on build
in
Shop Talk
I am a lurker too
see more
265 replies | 55144 view(s)
04-23-2024,
07:53 AM
mustangeddie
replied to a thread
Axle Seal Replacement
in
Shop Talk
Put the RTV around the perimeter of the seal before you put it in the housing. If you change your mind about a girdled cover a have a couple to sell.
see more
10 replies | 200 view(s)
04-23-2024,
07:01 AM
crouse
replied to a thread
Axle Seal Replacement
in
Shop Talk
I did remove the ABS sensors, but not the pin. :( I'll try again this weekend. At least I have the re-useable gasket now. Axles, bearings and...
see more
10 replies | 200 view(s)
04-22-2024,
05:59 PM
mustangeddie
replied to a thread
Axle Seal Replacement
in
Shop Talk
Did you remove the abs sensors, you need to at least move them in about 3/8" if you don't want them off completely and remove the center pin to get...
see more
10 replies | 200 view(s)
04-22-2024,
02:30 PM
TORINO
replied to a thread
Axle Seal Replacement
in
Shop Talk
Yes the big pin in the center has to be removed. When the seal leaks it usually means the axle and bearing is bad, but maybe just junk seals. ...
see more
10 replies | 200 view(s)
04-22-2024,
01:25 PM
crouse
replied to a thread
Axle Seal Replacement
in
Shop Talk
Would removing the pin allow the axles to push in farther?
see more
10 replies | 200 view(s)
04-22-2024,
11:38 AM
03Merc
replied to a thread
Rear Diff Cover w/ Drain Plug
in
Shop Talk
It's good to get one with bearing supports. They are cheap on eBay. Sent from my iPhone using Tapatalk Pro
see more
1 replies | 123 view(s)
04-22-2024,
11:34 AM
crouse
replied to a thread
Axle Seal Replacement
in
Shop Talk
This is the best video I've ever seen on the replacement of clutches. ...
see more
10 replies | 200 view(s)
04-22-2024,
10:45 AM
crouse
started a thread
Axle Seal Replacement
in
Shop Talk
So, I tried to change the axle seals this weekend. I removed the rear wheels, brake calipers and wheel sensors. I removed the rear cover, but...
see more
10 replies | 200 view(s)
04-22-2024,
08:37 AM
CWright
replied to a thread
"In Memoriam....." forum
in
In Memoriam
Jerry just told me! Mike was an awesome man and good friend!
see more
143 replies | 61138 view(s)
04-22-2024,
07:38 AM
lji372
replied to a thread
Progress on build
in
Shop Talk
Just lurking No progress? :dunno:
see more
265 replies | 55144 view(s)
04-21-2024,
07:01 PM
crouse
started a thread
Rear Diff Cover w/ Drain Plug
in
Shop Talk
I'm looking for a rear differential cover with a drain plug. I don't need the girdled type. I'd like an aluminum color, not black or chrome. ...
see more
1 replies | 123 view(s)
04-20-2024,
03:33 PM
Lencac1
started a thread For Sale
03 Marauder 300B Medford OR
in
Marauders for Sale
Ok guys, you didn't like my number. SO why don't you try a number and let's see what happens. What do you think of $18.5K? As you can see from the...
see more
0 replies | 130 view(s)
04-19-2024,
02:10 PM
Comin' in Hot
replied to a thread
Trans kits.
in
Community Discussion
A factory spec rebuild with a J-Mod is what i would do.... and as long as you shut OD off when you go wide open thottle it should be fine.
see more
2 replies | 179 view(s)
04-19-2024,
07:28 AM
John
replied to a thread
Trans kits.
in
Community Discussion
By the way the car also has a supercharger making about 440 at the wheels
see more
2 replies | 179 view(s)
04-19-2024,
07:27 AM
John
started a thread
Trans kits.
in
Community Discussion
So speaking of Rinehart I got a tranny kit from him 20 years ago put it on about 8,000 miles and the car only has 28,000 and have it at the trass...
see more
2 replies | 179 view(s)
04-19-2024,
07:22 AM
John
replied to a thread
Org. Owner
in
Welcome Forum
Trans. From Reinhardt only has 20,000 miles on it and third gear is burnt out it's at the trans Trans shop now I meant to start a thread about...
see more
7 replies | 429 view(s)
04-19-2024,
07:18 AM
John
replied to a thread
Org. Owner
in
Welcome Forum
Well the tranny only has 20,000 miles on it so it's not exactly it's a success story with Reinhardt lol
see more
7 replies | 429 view(s)
More Activity
No More Results
No Recent Activity