Activity Stream

I had the same issue when I installed mine. They'll look just fine until the wheels are on and there's weight on the axle. Mine rubbed.

You need to tighten them in a fashion that when fully tight they clear everything. If it hasn’t rubbed through then loosen clock the line a tad and...

Wow this has been a for ever build. All great tings come in time. Keep use posted.

Whats the part numbers on both? If not the same, probably not.

Thanks yes changed that also and , at least the one that bolts to the column above your knee if you were in drivers seat .. It will turn ign. on just...

Yes , you are correct I re checked and the relay does have four wires and they are all tight and free of corrosion in pdb I was able to get a better...

Yeah when i heard 3 wires at the relay that did not sound right

This has been a long time coming! You're going to need to take a couple weeks of vacation and just drive!!!

The COVID-19 supply chain issue cost me many months. As of today, Reliable Carriers set to pick up my baby from MOs Speed Shop in 2-4 weeks. The best...

See if the PCM isn’t actually sending a ground signal instead of a positive to trigger the relay. Never heard of a 3 legged relay? Like stated a...

The cost of the gear would outweigh the cost of a new actuator.

I would also try this^^^^^^^

I'm wondering, with all the ingenuity here, why doesn't someone make and sell a replacement gear for the actuator made of brass or aluminum? Sent...

Relays are basically electrically-operated switches. Usually they have (4) wires. Sometimes 5. (2) of the wires would be the high current circuit,...

Of corse, but there is no way for anyone to know PMstatus.

I just graduated! On blend door Wasn’t that bad at all, after I thought “why didn’t I do this a year ago?”

agreed, this will just get me up and running again... whatevers next remains up in the air... either rebuild and stroke the original, or work towards...

I respect your efforts and perseverance in trying to get your 4.6 repaired and running properly! Personally, I gave up on spending any time and...

looking good.... I especially like the cam and coil covers! Sent from somewhere near my Marauder using Tapatalk

First dibs on post may not be first dibs by a pm.

Still gonna be some time to pull my engine, swap parts as well as give the replacement a once over, but a big step was made today! Sent from...

Painted front brake calipers, changed oil and filter, and installed Coil covers on stock black valve covers until I get a chance to replace the valve...

I was very first to respond, and called dibs! So I thought he was waiting for my address to figure postage.

Thanks relay is good only three wires under the relay 1 is for 12volts that works 2nd wire is directly to solenoid on starter i jump from 12 volts to...

Don't know much about cars/electronics, but when you say you 'jump' the relay, is this the same as bypassing it? If the only time the car will start...

yes, it is flashing until you turn the key to the on position??

Thanks yes gave that a shot also nothing even tried moving the neutral safety switch a little still nothing but Thank you..

Is the PATS light working on the dash? Is it flashing?