View Full Version : Coolant crossover and bleeder
376shovel
01-30-2016, 08:13 AM
Looking for info on the part number of the bleeder and where I can get a new one. I read somewhere about a stainless steel one?
Also, does anyone know where to get the actual crossover tube. Mine works for now, but before I try to loosen the bleeder I want to be sure I can replace it if it breaks.
RubberCtyRauder
01-30-2016, 08:30 AM
crossover tubes are delete..hard to find and can be pricey. Here and ebay they pop up time to time. Member lji372 makes SS cap for bleederone using a wrench head rather that square drive. if you open it , makes sure you burp the system of air after or it may overheat.
376shovel
01-30-2016, 09:07 AM
So what's the solution to the crossover tube? A kit?
RubberCtyRauder
01-30-2016, 09:28 AM
ON3performance makes a COT delete kit, but not Marauder specific. I know nothing about it, a couple here I believe have them.
MOTOWN
01-30-2016, 11:31 AM
Xover delete is the way to go!
376shovel
01-30-2016, 12:52 PM
$288. That sucks.
RubberCtyRauder
01-30-2016, 01:01 PM
I think there are other configurations than $288. I saw something fir $180 on their site
376shovel
01-30-2016, 01:11 PM
Yes but its another 69 for the AN hoses and fittings to finish the job, and about 15 for the 180 thermostat
MOTOWN
01-30-2016, 01:15 PM
If you want cheap head to the junkyard.
RubberCtyRauder
01-30-2016, 01:22 PM
Unfortunately there is not much that is inexpensive for these cars any more. Heck aftermarket headlights are up to over $400 a pair. Maybe I should sell my brand new oem marauder headlights for $600
lifespeed
02-02-2016, 12:40 PM
$288. That sucks.
These cars are not that expensive to maintain, although there are a few parts that cost more than taxicab parts.
Spectragod
02-04-2016, 04:09 AM
If you want cheap head, go to the junkyard.
I had to read that 3 times, above is what I read,been hanging on modded too long I guess.......lol
RubberCtyRauder
02-04-2016, 06:55 AM
I had to read that 3 times, above is what I read,been hanging on modded too long I guess.......lol
Like button:D
fastblackmerc
02-04-2016, 08:28 AM
Looking for info on the part number of the bleeder and where I can get a new one. I read somewhere about a stainless steel one?
Also, does anyone know where to get the actual crossover tube. Mine works for now, but before I try to loosen the bleeder I want to be sure I can replace it if it breaks.
PM sent.........
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions Inc. All rights reserved.