LED tail light questions

[daddyusmaximus]

Not wanting to hijack the other thread on the replacement lenses with LEDs... I like the standard tail lights, but was hoping for LED replacement bulbs that would fit in the original housing and be a bit brighter. How hard is it to get the resistance figured out to make them blink at the correct speed?

There was a guy talking about this I think. Sorry, but I couldn't find the thread. (didn't subscribe)

[lji372]

Not wanting to hijack the other thread on the replacement lenses with LEDs... I like the standard tail lights, but was hoping for LED replacement bulbs that would fit in the original housing and be a bit brighter. How hard is it to get the resistance figured out to make them blink at the correct speed?

There was a guy talking about this I think. Sorry, but I couldn't find the thread. (didn't subscribe)

Pm limited360

Oh James! :wave:

[fastblackmerc]

Go to :

https://www.superbrightleds.com/

You can also install an electronic flasher in the system.

[Limited360]

Not wanting to hijack the other thread on the replacement lenses with LEDs... I like the standard tail lights, but was hoping for LED replacement bulbs that would fit in the original housing and be a bit brighter. How hard is it to get the resistance figured out to make them blink at the correct speed?



There was a guy talking about this I think. Sorry, but I couldn't find the thread. (didn't subscribe)


I sell plug and play resistors that are only on the turn signal line. PM me and we can discuss what you are looking for your specific vehicle.


Sent from my iPhone using Tapatalk so I may sound retarded.

[daddyusmaximus]

Cool. I will when I get home.

Sent from my SM-N910V using Tapatalk

[ChiTownMaraud3r]

Any 3157 led bulb should be able to fit, and I believe any 50 watt, 6ohm resistor across each turn signal line and ground should get the job done.