PDA

View Full Version : Steeda Spyder


Robronnie5
03-23-2016, 02:27 PM
Has anybody tried or know if Steeda Spyders will fit...especially the 20x11 for the rear?
Robronnie5
03-23-2016, 02:38 PM
Has anybody tried or know if Steeda Spyders will fit...especially the 20x11 for the rear?
RubberCtyRauder
03-23-2016, 02:39 PM
Need to know offset etc. bolt pattern , hub bore size , most likely 11" wide will hit shocks unless a spacer is used. Motown has some wide 20's on rear but think runs a spacer
MOTOWN
03-23-2016, 02:41 PM
I have a 20X11.5" on the rear , no spacers.
RubberCtyRauder
03-23-2016, 02:41 PM
Need to know back spacing. Hub bore size. 11 wide may rub shocks uess right offset and used with a spacer. Motown has wide. 20's in rear, and I think runs a spacer.
Robronnie5
03-23-2016, 02:43 PM
Wheel Height 20"
Wheel Width 11"
Finish Black w/ Machined Face & Lip
Casting Low Pressure
Hub Bore 70.6 mm
Bolt Pattern 5 x 114.3 mm
Offset 59 mm
Robronnie5
03-23-2016, 02:44 PM
What wheel are you running and on you on stock ride height? What tire size are you using? Thanks in advance
MOTOWN
03-23-2016, 02:45 PM
Wheel Height 20"
Wheel Width 11"
Finish Black w/ Machined Face & Lip
Casting Low Pressure
Hub Bore 70.6 mm
Bolt Pattern 5 x 114.3 mm
Offset 59 mm

That offset wheel will not fit , you need a +40mm offset wheel to run that width.
Robronnie5
03-23-2016, 02:47 PM
That offset wheel will not fit , you need a +40mm offset wheel to run that width.

Do you have any pics of your setup and what wheel and tire combo are you using?
MOTOWN
03-23-2016, 02:51 PM
It's around here some where , ill have to look for it.
Robronnie5
03-23-2016, 02:55 PM
It would be greatly appreciated
RubberCtyRauder
03-23-2016, 02:57 PM
Roger, do you have a spacer for front then? Hard to remember everyone's particulars
MOTOWN
03-23-2016, 03:00 PM
Roger, do you have a spacer for front then? Hard to remember everyone's particulars

No spacers on this setup , i ran spacers on the oem widened wheels because of their +50mm offset.