On3 kit question.

[parker]

Did any of you guys running the On3 crossover delete have to drill holes in the thermostat to keep a little bit of a flow around it for the factory sensor? Or did you plumb a bypass for it through the housing?

[MOTOWN]

There is absolutely no need to drill a hole in the thermostat, the on3performance kit uses a 54mm small block chevy thermostat.

[parker]

There is absolutely no need to drill a hole in the thermostat, the on3performance kit uses a 54mm small block chevy thermostat.



Yea I found my problemhttp://uploads.tapatalk-cdn.com/20160829/46ad9c483e41530940dd05e4761d0c d0.jpgDuma$$ forgot to pull the little piece of rag out I was using to block the hole over night.

[Fastbob]

Yea I found my problemhttp://uploads.tapatalk-cdn.com/20160829/46ad9c483e41530940dd05e4761d0c d0.jpgDuma$$ forgot to pull the little piece of rag out I was using to block the hole over night. I hate to ask, but who was the dumb a$$?

[parker]

I was [emoji20]

[parker]

I hate to ask, but who was the dumb a$$?



I was [emoji20]

[Fastbob]

I was [emoji20]Been there......or real close to there.

[parker]

Been there......or real close to there.



Well S*#t happens.
Won't be the first time, won't be the last.
At least I'm smart enough to figure it out.

[ledzilla]

How is that On3 kit? I've been giving it some serious thought. Anything to consider before making the purchase? You know, besides leaving a rag where it shouldn't be?

[parker]

How is that On3 kit? I've been giving it some serious thought. Anything to consider before making the purchase? You know, besides leaving a rag where it shouldn't be?



I think it's awesome. Makes the engine bay look clean. Only thing I can think of is make sure you use the right degree fittings, I put 90° ones on the heads and one 45° and one 120° on the thermostat housing. And if I was you I would go ahead and get the Reisch 170° thermostat while your in their. Also the rag is optional!