Torque

[MunsterBro95]

So starting the engine this weekend and don't know what torques I need everything at. Does anyone know where I can find the specs or know them so I can torque everything to the right when I put it all together?

[Joe Walsh]

IIRC.... there is a 'sticky' thread from wayyyy back when with all of the engine bolt torque specs.

[justbob]

Alldatadiy.com is worth every penny.

I have a dozen or so vehicles on my account at any given time.


Sent from my iThrone using Tapatalk

[fastblackmerc]

Just remember................ most MM torque values are more than a "ricer" motor is capable of!

[MunsterBro95]

Will those websites tell me the torque for using MM heads on a teskid block? Not sure if the torque is different

[fastblackmerc]

Will those websites tell me the torque for using MM heads on a teskid block? Not sure if the torque is different

I don't think the torque vales are any different.

I have a FORD Shop manual at home. If I get a chance I'll publish the toruque values.

[MunsterBro95]

I don't think the torque vales are any different.

I have a FORD Shop manual at home. If I get a chance I'll publish the toruque values.

Thank you sir

[Mr. Man]

Look in the DIY forum.

[justbob]

FYI There is no "one" torque. It's a series of six steps in sequence and no the specs aren't any different.


Stage 1 - 30 ft. lbs.
Stage 2 - additional 90 degrees.
Stage 3 - Loosen the bolts a minimum of one full turn.
Stage 4 - 30 ft. lbs.
Stage 5 - additional 90 degrees.
Stage 6 - additional 90 degrees.





Sent from my iThrone using Tapatalk