PDA

View Full Version : Oil pressure sensor



burt ragio
12-01-2016, 07:19 PM
I have a Autometer oil pressure gauge P/N 4927. My oil pressure sensor down by the oil filter is leaking. What is the replacement P/N ?

JimP
12-01-2016, 08:16 PM
You need the autometer 2242 short sweep sending unit. Also referred to as a transducer. About 35$ Make sure it's the sending unit before you order one, these motors are known to leak in that area too, also an easy fix.

03Merc
12-02-2016, 06:43 AM
I have a new sending unit if You need.


Sent from my iPhone using Tapatalk

fastblackmerc
12-02-2016, 06:55 AM
As stated the sender is 2242.

On a side note, the original sender that came from Autometer took a dump about 3 months after I installed it. The replacement has been fine for13+ years.

crouse
12-02-2016, 12:01 PM
I thought my sending unit was leaking, but it turned out it was a gasket on the flange where the oil filter mounts. FYI.

Marauderjack
12-03-2016, 03:28 AM
I thought my sending unit was leaking, but it turned out it was a gasket on the flange where the oil filter mounts. FYI.

^^^This!!^^^:cool:

fastblackmerc
12-03-2016, 06:38 AM
As mentioned, could be the oil filter adapter gasket. I'd clean the area and monitor it.