FUEL PUMP HANGER ASSEMBLY

[parker]

Any recommendations or bad luck with aftermarket fuel pump hanger assembly?


I am planning on building a twin pump set up and just don't want to have to pull it out a second time.

[Seneca]

Any recommendations or bad luck with aftermarket fuel pump hanger assembly?


I am planning on building a twin pump set up and just don't want to have to pull it out a second time.

I picked my extra pump assembly up from a you pick it yard, oem are stainless, not sure of after market, I actually used to hangers yo make one for twin pumps I was very pleased with the outcome

[Seneca]

Here's a pic of mine for reference

[justbob]

Stock hat, twin pumps. Nothing fancy, just worm clamped together.

The blue fitting on the right is actually my return. The stock line is my primary, the blue on the left is secondary. Both Aeromotive 340’s and supported 704 RWHP with plenty more on tap.

https://uploads.tapatalk-cdn.com/20180626/5d62e0982605d529af3c65e572403b e9.jpg
https://uploads.tapatalk-cdn.com/20180626/889e4bc3266d13a3fe8518b74fb8bd ef.jpg
https://uploads.tapatalk-cdn.com/20180626/ec79d5e88edafde866348ecf02ba90 6d.jpg


Sent from my iPhone using Tapatalk

[musclemerc]

Dual GT Supercar pumps, dual PPRV's, separate brackets and wiring:

Returnless

http://i790.photobucket.com/albums/yy182/musclemerc/IMG_1070.jpg

http://i790.photobucket.com/albums/yy182/musclemerc/IMG_1074.jpg

[parker]

So did y’all have to wire each one separately to a separate FPDM or just together?

I have a an upgraged one from RacerX and a BAP.

[musclemerc]

I have separate FPDM's. You can run both to the single FPDM if you like.

I'd still run separate wiring to each pump

The other posts are return setups so no FPDM

[parker]

I have separate FPDM's. You can run both to the single FPDM if you like.

I'd still run separate wiring to each pump

The other posts are return setups so no FPDM



Ok thanks I may PM you and pick your brain through the process once I collect all the parts.

[musclemerc]

If I can give advise it would be: don't use high draw pumps if your using a single FPDM.

Wiring upgrade is a must no matter what.

[MOTOWN]

Here is a Division X 03/04 Cobra hat I modded to fit in the Marauder tank Dual walbro 400lph pumps -8 an inlet/outlet , this may be posted for sale soon!

http://i1020.photobucket.com/albums/af324/sims36/20130330_140024_zps5f96aff4.jp g

http://i1020.photobucket.com/albums/af324/sims36/20130330_140013_zpsef49ffcd.jp g

http://i1020.photobucket.com/albums/af324/sims36/20130330_140003_zps340fcabe.jp g

[mm svt]

Looks good, do the bolt patterns match? Currently in the process of using the same pumps and going return deadhead . Parts will be here tomorrow