Shifter linkage adjustment

[badass mm]

What's the easiest way to adjust the linkage for the floor shifter

Sent from my SM-J337AZ using Tapatalk

[badass mm]

What's the easiest way to adjust the linkage for the floor shifter

Sent from my SM-J337AZ using TapatalkDo you have to take the center console out?

Sent from my SM-J337AZ using Tapatalk

[fastblackmerc]

Do you have to take the center console out?

Sent from my SM-J337AZ using Tapatalk

No, the trim with the cup holders comes out.

What are you trying to do?

[badass mm]

Trying to adjust the cable it's a little sloppy

Sent from my SM-J337AZ using Tapatalk

[Zack]

At the transmission. I suggest saturating the nut for days if not weeks with pb blaster if you’re in a rust belt. Break the stud and you’re replacing the cable. Not a fun job

[justgod]

At the transmission. I suggest saturating the nut for days if not weeks with pb blaster if you’re in a rust belt. Break the stud and you’re replacing the cable. Not a fun job

Yup! What Zack said. Don’t bust a nut to break a stud...:P

[badass mm]

So there's no way to adjust it from the inside at the shifter I crawled underneath there didn't really see a place for it to adjust underneath maybe I didn't look close enough

Sent from my SM-J337AZ using Tapatalk

[justgod]

Follow the trans cable under the drivers side of the engine to the shifter at the trans. There’s a big nut right at the end of the cable. There’s a lot of adjustment once you loosen that a little. Be careful if you’re under the car and have it out of gear!

[Lowndex]

Yup! What Zack said. Don’t bust a nut to break a stud...:P

I am stealing this line. Pure genius.

[badass mm]

The old girl finally turned over a hundred thousand my 03https://uploads.tapatalk-cdn.com/20180913/f6571147c1ae0071f856c729b72481 90.jpg

Sent from my SM-J337AZ using Tapatalk

[1Marauder]

Best $20 I ever spent at a transmission shop. My shifter was loose and sloppy and I hated it. 10 min and $20 it felt like new!