azgolfrat
01-09-2022, 04:18 PM
Hey Guys,
I'm doing some final checks the MM before starting it (scheduled for this Wednesday coming). The car has not been started or driven since all the work began.
The RideTechs in front, from Chris at ADTR went in fine. At the same time, I added the SPC camber bolt mod, which involved shaving out some of the frame/kmember to increase camber adjust.
(87365 - Camber Adujstment Bolt - Specialty Products Company - YouTube (https://www.youtube.com/watch?v=bCen_aVMyco))
Yesterday, using the Ridetech instructions, I went to adjust the Spring height; The curious thing is that the spring retainer nut on one side will not go as high up as the other..about 1.5 cm difference. Using the wrench included the retainer nut that is low cannot easily be moved any higher, yet the nut that is higher up, can be moved farther up still, relatively easily.
Any ideas why this might be the case?
I appreciate the help.
Thanks
I'm doing some final checks the MM before starting it (scheduled for this Wednesday coming). The car has not been started or driven since all the work began.
The RideTechs in front, from Chris at ADTR went in fine. At the same time, I added the SPC camber bolt mod, which involved shaving out some of the frame/kmember to increase camber adjust.
(87365 - Camber Adujstment Bolt - Specialty Products Company - YouTube (https://www.youtube.com/watch?v=bCen_aVMyco))
Yesterday, using the Ridetech instructions, I went to adjust the Spring height; The curious thing is that the spring retainer nut on one side will not go as high up as the other..about 1.5 cm difference. Using the wrench included the retainer nut that is low cannot easily be moved any higher, yet the nut that is higher up, can be moved farther up still, relatively easily.
Any ideas why this might be the case?
I appreciate the help.
Thanks