Eaton Swap Guys...I have a question.

[03Merc]

I'm using the IAT2 sensor that's mounted on the back of the Blower. Am I using all 4 wires? 2 from EGR harness and 2 from the MAF? All the wires are green on the pigtail for the IAT2 but I do have the pin out schematic. I'm just unsure wether to use only 2 wires from the EGR plug or just 2 wires from the MAF plug. Lmk what You did if You've done this b4! Thank You! https://uploads.tapatalk-cdn.com/20230513/59c59b506653c5c54f8ae409f47b15 e0.jpg


Sent from my iPhone using Tapatalk Pro

[Comin' in Hot]

what does the trilogy manual say?

[03Merc]

what does the trilogy manual say?

It uses the 2 wire IAT.


Sent from my iPhone using Tapatalk Pro

[musclemerc]

The IAT sensor is located in the MAF....

Read the eaton swap thread....

[03Merc]

The IAT sensor is located in the MAF....

Read the eaton swap thread....

Idk what You are trying to say but reading 500 pages for one thing doesn't seem thrilling to Me. Haha


Sent from my iPhone using Tapatalk Pro

[musclemerc]

Idk what You are trying to say but reading 500 pages for one thing doesn't seem thrilling to Me. Haha


Sent from my iPhone using Tapatalk Pro

You could always put it in the lower intake, post boost for a whole number of reasons.

[FordNut]

Use the cobra IAT/MAP sensor.

[justbob]

The IAT2 was an upgrade to the original Trilogy. When they sent mine out it came with a new drilled and tapped lower intake and a two wire sensor.

The wires hooked up to both outside grey wires of the MAF in any order. Simply cut them off and reroute to the new sensor. Use the sensor Fordnut listed.


Sent from my iPhone using Tapatalk Pro

[03Merc]

The IAT2 was an upgrade to the original Trilogy. When they sent mine out it came with a new drilled and tapped lower intake and a two wire sensor.

The wires hooked up to both outside grey wires of the MAF in any order. Simply cut them off and reroute to the new sensor. Use the sensor Fordnut listed.


Sent from my iPhone using Tapatalk Pro

https://uploads.tapatalk-cdn.com/20230519/09cb30eb9c43dd65ce80e73d0510ee d3.jpg



I'm using this sensor with 4 wires that was on one of the videos, I think I have it figured out! I'll find out soon.


Sent from my iPhone using Tapatalk Pro

[offroadkarter]

Use the cobra IAT/MAP sensor.


^This, I'm using the cobra IAT/MAP sensor and just didn't wire in the MAP part.

[03Merc]

Does anyone have a stock Marauder balancer for sale?


Sent from my iPhone using Tapatalk Pro

[mustangeddie]

Does anyone have a stock Marauder balancer for sale?


Sent from my iPhone using Tapatalk Pro
I have one

[03Merc]

I have one

Send pic! 561-706-3521.


Sent from my iPhone using Tapatalk Pro

[03Merc]

I have one

Thank You sir! Balancer received and installed. https://uploads.tapatalk-cdn.com/20230524/7918dfe457749b45c18947c8c7662e 04.jpg


Sent from my iPhone using Tapatalk Pro