azgolfrat
08-22-2024, 09:19 AM
Hey guys, The fuel gauge has stuck been on full through 2 tanks of gas. Reading older posts here , I am thinking the sending unit, and more specifically, the hanger/float/ohmic device isnt working right.
Any input on how to check the signal from this device ? Would it work to disconnect the sender wire connector that is outside the tank near the hatch and put an ohmeter on it? Any idea what kind of reading I should get if its working/not working?
thanks guys
ps - I will add some seafoam additive to tank after making measurements .
Sent from my iPhone using Tapatalk
Any input on how to check the signal from this device ? Would it work to disconnect the sender wire connector that is outside the tank near the hatch and put an ohmeter on it? Any idea what kind of reading I should get if its working/not working?
thanks guys
ps - I will add some seafoam additive to tank after making measurements .
Sent from my iPhone using Tapatalk