PDA

View Full Version : Dyno baseline numbers today



wesman
10-02-2004, 08:30 PM
I just got my car dynoed, 209hp & 235tq.
We ran into the factory speed limiter at around 200km/h or 124mph
We did the rest of the pulls in 2nd gear.
The car sounds awesome from the outside.
http://www.msprotege.com/members/Wesman%20II/1a/dyno%20baseline.jpg

Strapped down
http://www.msprotege.com/members/Wesman%20II/1a/Picture%20044.jpg

Blocked
http://www.msprotege.com/members/Wesman%20II/1a/Picture%20046.jpg

RRRRRRRRRHHHHHHH!!!!!!!!!
http://www.msprotege.com/members/Wesman%20II/1a/Picture%20049.jpg

http://www.msprotege.com/members/Wesman%20II/1a/Picture%20050.jpg

wesman
10-02-2004, 08:36 PM
It was on a Dynojet 248C, car was warm from an hour's drive and air temp is cool around 62.

FiveO
10-02-2004, 10:23 PM
Sorry...but that sounds reallllly low.

302 hp to the crank from the factory.

Thats almost a 33% power loss.

Power loss on a stock auto transmission should be about 20%....at most.


Wierd.



PS: Man....I'm really starting to like the blue color.... :)

Anyone else have thoughts on the numbers?

FiveO
10-02-2004, 10:25 PM
Ok...I took a bit of a closer look at the graph.

Your numbers on the graph seem a bit higher than 209 for rwhp....


Anybody have thoughts?

wesman
10-03-2004, 03:39 AM
It does seem low, but it might just be the dyno.

Smokie
10-03-2004, 04:38 AM
The numbers are low, but they are just that, numbers; how does the car feel when you hit the throttle ? If you want to know how your car stacks up, go to the track.

The average MM. does 15.2-15.3 in the 1/4.

sailsmen
10-03-2004, 07:17 AM
Temp and Humidty affect the 1/4 by +/- .75.

FordNut
10-03-2004, 07:23 AM
If the graphs shown were in 2nd gear that could explain the low numbers. I tried to do pulls in lower gears before and got bad results. Best way is 3rd gear, od off. And yes, the speed limiter kicks in before rev limiter, but it's still above the hp and tq peaks. Most of us got around 240 hp stock.