View Full Version : underdrive pulleys
bigmerc'03
10-22-2004, 09:58 AM
What are the torque specs on both pulleys to be tightend to crank? waterpump?
RF Overlord
10-22-2004, 01:46 PM
bm'03, I'll look in the service manual when I get home from work, if no one has the answer before then...didn't want you to think we were ignoring you...
valleyman
10-22-2004, 08:26 PM
What are the torque specs on both pulleys to be tightend to crank? waterpump?
Four bolts holding on the water pump pulley: 25 Nm (18 lb-ft).
Crankshaft pulley bolt: "Install the bolt and washer. Tighten the bolt in four stages. Stage 1: Tighten the bolt to 90 Nm (66 lb-ft).
Stage 2: Loosen the bolt one full turn.
Stage 3: Tighten the bolt to 50 Nm (37 lb-ft).
Stage 4: Tighten the bolt an additional 85 to 95 degrees.
So sayeth the shop manual.
bigmerc'03
10-22-2004, 10:43 PM
thank alot!!!!!!!!!!!!!!!!!:burnout:
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions Inc. All rights reserved.