PDA

View Full Version : Anyone make tailpipes??



NickT88LSC
03-01-2005, 06:41 PM
Hello all,

I have a 2000 Mercury Grand Marquis, is there anywhere to get tailpipes to run dual wheather 2 1/4 or 2 1/2????? Does anyone have Marauder Tailpies to sell????

Thanks,

Nick

SouLRioT
03-01-2005, 06:43 PM
one of our site vendors sells them:

http://www.innovativeinterceptors.com/

djv5150
03-01-2005, 06:46 PM
Hello all,

I have a 2000 Mercury Grand Marquis, is there anywhere to get tailpipes to run dual wheather 2 1/4 or 2 1/2????? Does anyone have Marauder Tailpies to sell????

Thanks,

Nick



TRY THIS VENDOR
http://www.innovativeinterceptors.com/

MarauderMark
03-01-2005, 06:46 PM
one of our site vendors sells them:

http://www.innovativeinterceptors.com/


^^^what he said^^^
http://innovativeinterceptors.com/

Didn't mrarudernkc buy a wrecked marauder and was selling parts ?Maybe give him a pm and see what he says.he may still have the exhaust..

djv5150
03-01-2005, 06:48 PM
Soulriot Beat Me To The Punchline

BillyGman
03-02-2005, 01:48 AM
But are you looking for just the stainless steel exhaust tips themselves, or are you looking for the tailpipes that go over the rear end axle tubes, and feed into the exhaust tips?

NickT88LSC
03-02-2005, 04:26 AM
I am looking for the entire tailpipe over the axle, I need to convert a single exhaust to dual, and these tailpipes have alot of bends, would be a little diffivult to bend nicely.

cyclopsram
03-02-2005, 04:47 AM
I am looking for the entire tailpipe over the axle, I need to convert a single exhaust to dual, and these tailpipes have alot of bends, would be a little diffivult to bend nicely.
Grand Marquis had duals available as part of the handling package in 2000. Just go to your friendly dealer and order the H pipe and the muffler and the hangers for the left side and bolt em on.... no welding no cutting no fuming.... or take a set off a used up Crown Vic P71 or handling package from a junk yard. They separate at the front of the muffler and may need a little tap or heat to get apart, but they will come apart and off you go. The units from 1998 thru 2002 should fit... in 03 the rear axle changed to outboard shocks so I don't know about newer.... It is possible that the folks at NAPA or similar will have a listing too... The whole thing hangs in donuts, but you may need to buy a few of them too... Or.. if you want the special stuff, you can buy nice looking and sounding sets from the fine vendors on this site... I have a BORLA setup I have used on 3 different cars... now on a 2003 P72,,, Million Mile warranty. Happy Motoring RAM

BillyGman
03-02-2005, 11:35 AM
You can always go to a Ford dealer parts department, or better yeet, write to Ray ("The dealer") who is a member here, and purchase the Marauder tailpipes which come with the mufflers welded on, and the polished stainless steel exhaust tips too. but I'm sure that it's a hefty price tag for that, and it would only suffice if you're looking to use the stock mufflers which is what it comes with.

Marauder8
03-02-2005, 04:41 PM
Hello all,

I have a 2000 Mercury Grand Marquis, is there anywhere to get tailpipes to run dual wheather 2 1/4 or 2 1/2????? Does anyone have Marauder Tailpies to sell????

Thanks,

Nick
We do custom exhaust. Home base is Cape Cod, Ma. PM if interested.