Reflashing at the track

[Rkammer]

I want to take my car to the track to get a baseline on it bone stock. Then, I'd like to reflash it with my DR Excal2 with the performance tune (which I already have) and install the CAI in the pits before making another pass. Can anyone tell me if I can just pull into the staging lanes after making the changes, or do I need to drive the car a certain distance so the computer can learn the new settings before it wil do any good? :rolleyes:

[SouLRioT]

From what I know, you should beable to go right back on once your done installing the CAI and the flash.

[RF Overlord]

Ray, the new parameters from your performance tune will take effect immediately after the flash. The only potential bug in your plan is that the PCM *may* take a few miles to adapt to the CAI...so you *may* not get a totally accurate before/after...

[Mike Poore]

I want to take my car to the track to get a baseline on it bone stock. Then, I'd like to reflash it with my DR Excal2 with the performance tune (which I already have) and install the CAI in the pits before making another pass. Can anyone tell me if I can just pull into the staging lanes after making the changes, or do I need to drive the car a certain distance so the computer can learn the new settings before it wil do any good? :rolleyes:
Ray, if it was me, I'd make a few passes without bringing it off the line too hard, and getting into it a little more on each sucessive run. By the end of three runs it should know what you're up to and get into it's "let's boogie" mode. :burnout: