PDA

View Full Version : Gods head emblems update...



looking97233
03-17-2003, 06:23 AM
Well, they new job fell through. I've been off work for over six months now. So, I'm not going to spend the money right now to build the furnace and other stuff I would need to cast the badges up at home. Today I am going to find a casting shop in town (hopefully) and find out what it would cost to do a run of the badges. I will update later.

LincMercLover
03-17-2003, 06:26 AM
Was wondering what ever happend to this.

prchrman
03-17-2003, 07:14 AM
If someone can carve some out of polystyrene (styro-foam)...I can cast them...alum. A356...might try one sample first to check quality...

mungce
03-17-2003, 07:58 AM
Any use for the Mercury Head found on the centers on each wheel ? I have 3 of them from a wheel replacment, and have wondered if a tail badge could be made. Possibly a side badge ?

Jim Williams
Ft. Worth, Tx

MAD-3R
03-17-2003, 08:03 AM
Those are what most people are useing for there badge replacement. Just remove the back badge, grind the waterfalls out, and glue in the godshead disk.