Log in

View Full Version : SC Install Complete...A/C Problem??


drdt340
09-13-2005, 01:32 PM
Ok...so my self installed Trilogy install went off without a hitch, performance wise. I have a problem now with my Air Conditioning though. When setting it to Max Cool or even regular vent, nothing comes out of the vents? The defrost and floor works fine along with the blower fan. I'm wondering if anyone has had a similar problem or knows any info on possible solenoids that control this unit?
torinodan
09-13-2005, 01:49 PM
did you check your vacuum lines from the eng?
drdt340
09-13-2005, 01:51 PM
Well, I'm gonna have to go through it all again yes. It must be something simple like that, but I'm wondering what vaccuum line it may be coming off the engine? Or something electrical?
MarauderMark
09-13-2005, 04:52 PM
Well, I'm gonna have to go through it all again yes. It must be something simple like that, but I'm wondering what vaccuum line it may be coming off the engine? Or something electrical?
Vaccum hooked to the wrong place..
Donna
09-13-2005, 05:09 PM
:congrats: on the self install and your new power. If you can not figure it out, call Jerry at Trilogy.....he may know of something. Have fun :burnout:
txmarauder
09-13-2005, 05:20 PM
If you installed the boost gauge in the center console gauge pod check all vac lines and wire connectors where you ran the boost line. You probably just knocked something off or loose.
Marauderjack
09-13-2005, 05:27 PM
I don't have a S/C yet but my AC did exactly the same thing today and it was ICE!!!! :censor:

The compressor was running all the time even with the climate control off!! :mad2:

Stopped in at Bob Bennett Ford in Columbia, SC and they took it right in and found the compressor switch was bad.....replaced it and I was on my way!! Since it was under warranty I was glad the SC was not there but it was only $80.00 if I had paid for it!!

Check and see if it is icing...all of my lines were white and I'm sure the condensor was as well....NO AIR COMING OUT AT ALL!!! :shake:

Works GOOD now!! :beer:

Marauderjack :)
jgc61sr2002
09-13-2005, 06:34 PM
Vaccum hooked to the wrong place..



What he said. or a disconnected vacuum line.
Blown3.8
09-13-2005, 07:02 PM
If you installed the boost gauge in the center console gauge pod check all vac lines and wire connectors where you ran the boost line. You probably just knocked something off or loose.
:stupid:
My t-bird had a vacuum line fall of under the glove box and when i turned on max ac it would work fine until i stepped on the gas and then it would just blow out the defrost.
MarauderMark
09-13-2005, 08:06 PM
:stupid:
My t-bird had a vacuum line fall of under the glove box and when i turned on max ac it would work fine until i stepped on the gas and then it would just blow out the defrost.
Oh man what a painful blast from the past ..i remember this... :rolleyes: