PDA

View Full Version : TA Rear end Cover Group Buy


maraudernkc
03-20-2006, 12:14 PM
Is anyone interested in a Group buy on the TA Performance rear end covers engraved with MARAUDER on it?

I will have to look into the Marauder name rights. Maybe someone else knows about the Marauder name rights. If we can not use Marauder than we can maybe come up with something else that can be engraved across the back.

Below is a link to the TA Performance Cover
Scroll down to the Ford 8.8 cover.
http://www.taperformance.com/rearend.htm

Here is the deal.

Must have 15 or more

Cost Including engraving is $159.00 plus shipping

We must all agree on the same engraving or we could have two runs of 15 sets.

How about some diffrent names for the back.

MARAUDER
SUPERCHARGED
BLOWN RAUDER:eek:

Let me know what ya think!

Greg
Mikeenh
03-20-2006, 12:28 PM
I'm in.

MARAUDER
MarauderMark
03-20-2006, 02:28 PM
Stock look ^^^^you will also need a stud kit.if not included i'll put up a link if you want.
Greg you sure being the busy beaver.:D
O's Fan Rich
03-20-2006, 03:05 PM
http://innovativeinterceptors.com/images/girdle1.jpg
Stock look ^^^^you will also need a stud kit.if not included i'll put up a link if you want.
Greg you sure being the busy beaver.:D
If the stud kits included I'm in....
TooManyFords
03-20-2006, 07:03 PM
I'm in for this too for Marauder. Maybe we can even get the same font from the back bumper?

Either way, I need one for when I swap the diff.

Cheers!

John
MarauderMark
03-20-2006, 07:25 PM
I'm in for this too for Marauder. Maybe we can even get the same font from the back bumper?

Either way, I need one for when I swap the diff.

Cheers!

John
your not going with 9" rear?
Rider90
03-20-2006, 08:31 PM
http://midwestpanthers.net/girdle.jpg
The hex-head bolt circled is one you should pay special attention to during the install. I used 75w-140 Motorcraft oil and I checked on the girdle 12 hours after the install and noticed a small amount of oil seeping out. You'll want to use teflon tape on this one. Also, toss the gasket, and use silicone.

Notice the bolt circle is not one that screws into the 8.8" rear end, but it is the service plug. And the large bolt on top, it does you no good. Don't fill up there - fill up on the opposite side like usual. If you fill up there, have the oil-dri ready.