4.10s going in today

[ductman]

My car is at the dealer today so my buddy can install the 4.10s. I can't wait to drive it! All of you guys have already said how great they are...I just hope I have no driveshaft vibration issues. I ordered the K&N cold air kit and flowmaster super 40's. I am also working on Steeda underdrives. I figured it has 9000 miles on it now, time to make it into what it should have been from the factory! After I get all of this in I am planing to get it tuned. Is there any other quick, easy, bolt on mods that I am missing(other than a supercharger), before I have it programmed?

[KillJoy]

That is about it! You are off to a good start!

KillJoy

[Blackened300a]

I just hope I have no driveshaft vibration issues

I have almost 16K miles on my 4.10's and I have hit speeds over 135MPh without a vibration.
You'll be fine

[ductman]

Did you get your steeda pullies locally(ny)? I still need to get them and install them before the tune.

[Blackened300a]

Did you get your steeda pullies locally(ny)? I still need to get them and install them before the tune.

PM Sent with some info

[Raudermaster]

How is the gas mileage now with 4.10's? That is the only thing holding me back from looking into getting them.

[RedMerc04]

How is the gas mileage now with 4.10's? That is the only thing holding me back from looking into getting them.
I lost about 2 or 3 MPG when i did mine; it could also have something to do with my foot being into it more too. Believe me you wont regret 4 10s

[Blackened300a]

Believe me you wont regret 4 10s

^^^^ What he said^^^^