Ride height??

[gmtech]

what is the normal rear ride height on 03 MM mine is sitting at 29.5 in

[LILALLEYKATT]

what is the normal rear ride height on 03 MM mine is sitting at 29.5 in
The normal height is wherever you want it...The MM's rear ride height takes 45 seconds to adjust....I just lowered mine yesterday. If you lower it to much it will ride like a lowered ricer. I had to raise mine back up a little to retain the good ride quality...

[gmtech]

The normal height is wherever you want it...The MM's rear ride height takes 45 seconds to adjust....I just lowered mine yesterday. If you lower it to much it will ride like a lowered ricer. I had to raise mine back up a little to retain the good ride quality...



Does yours still have slight rake or is sitting level?

[LILALLEYKATT]

Does yours still have slight rake or is sitting level?
I just put 255/55/s on the rear and because they are taller than the OEM 245's it felt like I had jacked up the rear so I had to lower mine to be comfortable..It still has a slight rake but the rear wheel wells are definately filled up now!

[dwasson]

29.5 inches measured where?

[LILALLEYKATT]

29.5 inches measured where?
I'll betcha lunch hes measuring from the top of the rear wheelwell arch to the ground...

[gmtech]

29.5 inches measured where?

centerline of wheel;from ground to bottom of rear quarter

[gmtech]

I'll betcha lunch hes measuring from the top of the rear wheelwell arch to the ground...


You got it

[michael ward]

The normal height is wherever you want it...The MM's rear ride height takes 45 seconds to adjust....I just lowered mine yesterday. If you lower it to much it will ride like a lowered ricer. I had to raise mine back up a little to retain the good ride quality...how do you adjust??

[Canadasvt]

how do you adjust??
/\ /\ /\ /\ /\

[LILALLEYKATT]

I backed mine up onto some ramps. Then you crawl under the rear and you'll see a rod that goes from the body to the rear end. Loosen the height sensor ball stud bracket retaining nuts=[2]=1..[8mm]..1[13mm] slide the bracket 1/16th to 1/4 of an inch and tighten...Start car and watch the height...You may need to ride around the block...The bracket you are looking for is black and it is on a galvanized arm...Hope this helps good luck ....