PDA

View Full Version : Passenger side head light assem.


Steve_NC
06-02-2007, 05:42 AM
I am looking for an OEM passenger side headlight complete assembly for the MM. I have seen the ones on Ebay and they say aftermarket. The one I have on the car right now is starting to fog up.
RoyLPita
06-02-2007, 06:03 AM
I know a member here who has one. I'll let him know about this.
fastblackmerc
06-02-2007, 06:27 AM
Steve, If it's foggy on the outside you can try polishing it. Most FLAPS have a kit to restore headlights. If it's foggy on the inside (goes away after you use the headlights) then there is a leak somewhere allowing moisture to enter the headlight assembly.
Steve_NC
06-02-2007, 10:41 AM
Its foggy on the outside, but the drivers side light assem was replaced by the previous owner. I want to get them looking the same, and save the old one for a spare.
Raudermaster
06-05-2007, 04:15 AM
The ones on ebay are stock. I mean, just take one look at them and I don't see anything "aftermarket" about them.
larryo340
06-05-2007, 09:23 AM
The ones on ebay are stock. I mean, just take one look at them and I don't see anything "aftermarket" about them.

how about where it says- condition: New Aftermarket
http://cgi.ebay.com/ebaymotors/03-04-MERCURY-MARAUDER-HEADLAMP-HEADLIGHT-LH_W0QQcmdZViewItemQQcategoryZ 33710QQihZ014QQitemZ3301272771 76QQrdZ1QQsspagenameZWDVW
1of327
06-05-2007, 10:54 AM
It is a bit expensive, but you should just order them from a dealer...If your know someone that works for one, they get an employee discount.
fastblackmerc
06-05-2007, 11:28 AM
Contact Ray the Dealer.
ckadiddle
06-05-2007, 02:36 PM
Does it have to be perfect? I have one in storage, cant remember which side it is from.... It had a scuff on it. I had it replaced with a new unblemished assy when other bodywork was being done.
jgc61sr2002
06-05-2007, 07:29 PM
I am looking for an OEM passenger side headlight complete assembly for the MM. I have seen the ones on Ebay and they say aftermarket. The one I have on the car right now is starting to fog up.

Most of the original head lamp assemblies fogged up.
There is a TSB from Ford with an updated part #.
CRUZTAKER
06-05-2007, 08:42 PM
Contact Ray the Dealer.

Exactly.

Member Ray, aka "TheDealer".

http://www.mercurymarauder.net/forums/member.php?u=1210

He is kind enough to give us BELOW cost on genuine Ford parts.
Take advantage of his offer.

Screw aftermarket parts.
MENINBLK
06-05-2007, 08:46 PM
I am looking for an OEM passenger side headlight complete assembly for the MM. I have seen the ones on Ebay and they say aftermarket. The one I have on the car right now is starting to fog up.

Buy a Mother's Powerball and use the Mother's Plastic Polish on it.
It will polish up like NEW !!!
ChiTownMaraud3r
06-09-2007, 10:21 PM
Actually I took apart the left headlamp/corner lamp assembly on my parents 03 GM, and let it air out for a while, after putting it by the dehumidifier. Cleaned up the fog and condensation real nice, no problems so far.
Marauderjack
06-10-2007, 03:33 AM
www.rockauto.com

They are $73.79 here but from "Various Manufacturers"......I bought a pair for my Ford truck and they looked very good for aftermarket??:beer:

Marauderjack:burnout:
ckadiddle
06-11-2007, 07:53 AM
Does it have to be perfect? I have one in storage, cant remember which side it is from.... It had a scuff on it. I had it replaced with a new unblemished assy when other bodywork was being done.
Never mind, found it cleaning out the utility room. Not headlight, just cornerlamp and turnsignal housing.