Log in

View Full Version : HELP! Does anyone know how to remove ....



Professor
07-02-2007, 05:39 AM
.... the trim around the shifter. I've ordered a shop manual but it hasn't come in yet. I want to replace the trim around the base of the shifter (the dot matrix looking piece). However, I don't know how to remove it from the base of the shifter. I assume that you just remove the shifter knob then (carefully) pry loose the trim. But I am not certain of that. Does anyone know for sure?

Thanks!

Zack
07-02-2007, 05:57 AM
The black sleeve below the shifter handle slides downward exposing 2 torx bolts.
The rest is just held in by clips.

GA-Marauder
07-02-2007, 07:28 AM
Hey Prof, what are you replacing it with???

fastblackmerc
07-02-2007, 08:45 AM
See Zack's reply on getting the shift handle off. To get the shifter bezel off you need to take out the gauge pod by pulling up and towards you, then you have to remove the top of the console which is just held in with clips if I remember correctly. I believe there are a few screws to take ou to remove the shifter bezel. You'll see it once you get in there.