MT Street DRs

[Glenn]

Has anyone used the MT 345x35x18 ET Street DR? Will this tire even fit on a MM? Interested in any information.

Glenn

[merc]

Has anyone used the MT 345x35x18 ET Street DR? Will this tire even fit on a MM? Interested in any information.

Glenn

Glen you may need to have 12-13.5 inch wheels. That will be tricky. Even with smaller wheels the tire rub could cause problems.

[sailsmen]

U may want to go w/ what Merc , others and I have. ET Streets.

They fit in the trunk and a Harbor Tools Al jack and u are good to go. Tire Rack makes a tire cover/carrier that protects the trunk and makes them easy to handle.

Taking your time it's 45 minutes to swap and set the car up for the track.

If u keep 25 psi they are ok, less and be careful. U may need tubes and screws.

[RaceLegend79]

I dont know about storage going to the track but just to mount up youll need only a 10' wheel but to fit in back will be very tight fit, if someone has the ability to test then yeah do it. But if it will cost you money just to test I would go for the sure thing and follow the tried and true that everyone else has done.

[Glenn]

Thanks for the comments fellows. Just have to think things over.

Glenn

[Marauderman]

Thanks for the comments fellows. Just have to think things over.

Glenn

You know I am watching what you do here---cause you found the answer the last time for wheels......so let it be known when you find out stuff---cause I am interested too.....BTW--Wasn't MT going to or supose to have a tire ready (18) with 10"wheels.. for us by fall or was it last fall?....heard anything on that Glenn?

[Glenn]

It's a no go for MT ET Street Radials in 305x45x18 which would have been a great replacement for our Nittos of the same size. But, MT said NO they are not going to come out with this size for our MM. The closest size is the Mustang sized 305x35x18 which is a no go for MM at 26".

Glenn