How to...

[captain]

I am going to do the upgrade to granettelli. The thread posted with pictures is perfect...How do I get it off the site and into my greasy little hands? Is it printable or do I move it to a folder? if so how??

[MM2004]

I am going to do the upgrade to granettelli. The thread posted with pictures is perfect...How do I get it off the site and into my greasy little hands? Is it printable or do I move it to a folder? if so how??

Right click the image and 'save as' to your computer. You should be able to print them from there.

Or, leave the thread open to the images, save your ink and each time you reference the install pics, grab a cold beer. :D

:beer:

Mike.

[fastblackmerc]

It's not rocket science to change the COP connectors. You also might want to check / change your plugs while your in there.


Remove the 2 10mm bolts from the coil cover
Clean up any debris in the spark plug well
Disconnect a coil connector
Pull the coil out
Take off the spark plug boot
If the OEM spring is still attached, remove it
Install the new connector (wire) to the coil
Install the new spark plug boot
Put a dab of dielectric grease on the plug end of the spark plug boot
Push the assembly onto the spark plug
Reconnect the coil connection
Repeat for the other 3 coils
Put some silicone sealer on the coil cover where the wiring harness exits to the rear
Install the coil cover and retaining bolts
Repeat for the other side

[2,4shofast]

I did have a question on the Granettelli upgrade, are the COP connectors required for the upgrade or just something that is recommended? Just thought I would ask :o

[captain]

Based on the quality of the factory part... not sure they would even be reuseable. They are really tough to remove without stretching them. Plus if you value your time at all. toss em.