Need Help Asap

[piglit50]

i was trying to run my fuel line for my new nitrous kit and while removing my fuel pressure sender, the 1/18 male to 1/8 female fitting on my fuel rail snapped and with nothing for me to grab with pliers or anything... i need advice on how to remove.

[O's Fan Rich]

You'll more than likely need a screw extractor kit or tool of some sort, then you'll have to clean the lines.

[piglit50]

thanks i thought so... now i have a reason to buy one. LAMO

[hot-rauder]

thanks i thought so... now i have a reason to buy one. LAMO


they are always handy to have

[magindat]

If you have a dremel with a cut off wheel, you can carefully cut a slot into the piece that's stuck and remove it with a straight blade screwdriver.

[Zack]

If you have a dremel with a cut off wheel, you can carefully cut a slot into the piece that's stuck and remove it with a straight blade screwdriver.

Doubtful Rich, those are pipe threads.

[hot-rauder]

Doubtful Rich, those are pipe threads.

Pipe threads= the devil..... even with an easy-out they can be tough. good luck

[piglit50]

i did it...not sure how but i did.. thanks guys