center console install

[superford3]

can anybody show me an install procedure on how it mounts to the floor please ?

[KillJoy]

can anybody show me an install procedure on how it mounts to the floor please ?


For a???? Marauder??? Mustang???

:dunno:

KillJoy

[ImpalaSlayer]

prolly his CV.

[Pops]

Its not hard but I have no pictures. Just locate it where youy want it and drill holes. Be carful of the bolt length as they will hit drive shaft if they are to long! Dont ask how i know this. You will have to remove the seats to drill the holes/

[magindat]

Lift the storage compartment straight up - hard.

There are two bolts underneath. Remove.

Two alan or torx screws to hold the shifter knob. Loosen and remove. Lift straight up.

Pull entire assembly back and angle up from rear.

I think that's all I remember.

You may see something else while you're in there, but that'll get you started.

[superford3]

I bought one to install in a vic but I think there is a base that I am mmissing

[O's Fan Rich]

I bought one to install in a vic but I think there is a base that I am mmissing

This may be it.

[Rocknthehawk]

Yes, the base which everything mounts to is a large, heavy gold bar.

[superford3]

Thankyou guys that helped a ton

[Stranger in the Black Sedan]

Make sure you don't DRILL into the driveshaft either. One of my friends used to work in the service dept at a local ford dealer. He was asked to order 10 new CVPI driveshafts one day and wanted to know why. A contractor hired to install the electronics in new cvpi's drilled holes through all 10 new car's driveshafts.

LOL

[blackhueys]

wont holes make the driveshafts better like cross drilled brake rotors? ha ha lol

[RF Overlord]

...and your new "cross-drilled" driveshaft will be lighter, too, so you can safely drive at much higher speeds now.

[Stranger in the Black Sedan]

A d/shaft with a hole in it would become a friekin organ pipe at the right speed