View Full Version : Heated Seat switch throwing a code?
gnxtc2
07-09-2008, 07:14 PM
Got in the MM this morning at 4am to go to the gym. I look over to the passenger side and see the heated seat switch blinking as if it was throwing a code. I did not count them but there were like 3 long blinks with a few short rapid ones.
Is this possible? What's going on?
Thanks
Billy T.
gnxtc2@aol.com
FordNut
07-09-2008, 09:22 PM
No code, just random blinking. Needs a new switch. The LED is intermittent. Common problem.
jonroe
07-10-2008, 04:29 AM
On a related note I just had BOTH heated seat elements (both sides) replaced under warrantee. Seems kinda lame for them to both go at 49K miles.
fastblackmerc
07-10-2008, 05:10 AM
Mine were replaced at around 10K miles.
jonroe
07-10-2008, 06:29 AM
So far, after 49K miles, the only unexpected failures I have had with the car have been the Lighting Control Module, the heated seat elements, and the heated seat switches. All have been replaced under warrantee. I wonder if I should fear electrical failures after the warrantee runs out!
Eric91Z
07-10-2008, 06:33 AM
My driver's side one went out with around 20,000 miles or so and replaced under warranty. The passenger side one started blinking last year. And since I have put less than 2000 miles on it in the last year I have yet to replace it. I did get a new switch, but just haven't taken the time to install it yet.
MM2004
07-10-2008, 07:23 AM
IIRC, the switch is around $50.00 each. Labor, about 30 minutes per side.
Both mine replaced under 20k.
Very common problem with the MM, GM's and CV's.
Most Dealers stock this part.
Mike.
FordNut
07-10-2008, 10:12 AM
Order the switch online (or call Ray) and it costs about half that price.
Richy04
07-10-2008, 02:24 PM
repair it, or if you dont, send me your old ones for the parts exchange program..
CRUZTAKER
07-10-2008, 02:28 PM
Perhaps it's Morse code....:dunno:
If it's blinking .- ... .- ...
It's telling you it want some ass. :baaa:
sicilianmarquis
07-10-2008, 03:03 PM
+1 on ford nut, the only way to retreve codes is the eatc,stock radio, or the scan tool, the heater switch it not a code giver, replace the swithc
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions Inc. All rights reserved.