View Full Version : uneven tailpipes
the fat bastid
09-08-2003, 05:48 PM
anyone else have uneven tailpipes?
my drivers side pipe acutally touches the bumper cover (in the top right of the cut out for it) and the other one seems to be fine, if not a little low (when compared to the other one)
LincMercLover
09-08-2003, 06:15 PM
I'm sure it can be adjusted by a simple hanger adjustment. All they do is heat it up a lil and bend it. No biggie...
Logan
09-08-2003, 06:18 PM
Not even, When I picked mine up, it was uneven, I got down and looked up underneath and the rubber hanger thingy was out of it's groove... Just used a screwdriver to pop it back to where it needed to be... About a 30 second fix.
RF Overlord
09-09-2003, 09:17 AM
^^^what Logan said^^^
My left pipe was offset inboard; it was just the flubber hanger had been installed by a gorilla...popped it back, and: "Wallah!"
the fat bastid
09-09-2003, 02:45 PM
i checked it out. not only was the flubber hanger not over all the way it looks like it is slighty deformed as well. warranty..hoooooo!!!
Constable
09-10-2003, 04:38 AM
Mine came from the factory witht he pass. side pipe about 2" inward... same easy fix
Cinelli
09-10-2003, 10:43 AM
I does make you wonder if the same level of competence used to hang the exhaust system was also used to assemble the engine. And then FMC is concerned if one of us voids the warranty by just installing a CB radio or radar detector. Makes good sense to me.
RF Overlord
09-10-2003, 01:33 PM
ROFL!
Good point, Cinelli...
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions Inc. All rights reserved.