Installing upper and lower intake questions.

[Embassy]

For some odd reason, a ported and polished upper and lower intake is being dropped off on my doorstep today. :cool:

Therefore, I could use some tips on installing it.

Specifically, what are the torque specs for the upper, lower, and intake spacer?

Also, what is the sequence to torquing it all down?

Anything else I need to know is also appeciated.

Thanks.

[fastblackmerc]

I posted them earlier... for the upper intake

Search.

[larryo340]

I have all you need, but from the factory manual the attachment is too large. PM me your email and I will email it to you.
ps
Is it for a 2V or 4V ? and year ?

[Zack]

You dont need to torque the bolts :rolleyes:

[FordNut]

I think they're 89 in-lb. My torque wrench only goes down to 10 ft-lb so I just use that setting. Works fine.

[Embassy]

Thanks for the replies, gentlemen.

Any other tips or suggestions are appreciated.

[Georges93LX]

Thanks for the replies, gentlemen.

Any other tips or suggestions are appreciated.

You could install them on my car for practice. I promise to give them back eventually.;)

[justbob]

Easy job, you'll do just fine.

[Drewstang]

Tighten until they break, then back off a quarter turn.