PDA

View Full Version : looking for an A/M


Blk Mamba
09-04-2009, 12:21 PM
I'm looking for an after market part, for a cold air intake system I'm making, I saw it on a web site, and thought I book marked it, but now can't find it. The rubber connector between the throttle body, and the intake tube, it was listed for $13.
ImpalaSlayer
09-04-2009, 12:25 PM
www.frozenboost.com (http://www.frozenboost.com) i belive you want a 4.5 inch. may wana double check.
FordNut
09-04-2009, 12:25 PM
Maybe not the same place you saw it, but turbohoses.com has about everything along those lines.
Blk Mamba
09-04-2009, 12:40 PM
Thanks, I'll check them.
cougar9150
09-04-2009, 12:55 PM
So does Spectre that is specifically made for the 4.6L oval throttle body P/N 9791. I used one on my first MM for the home made CAI I made. It was the exact dimensions of the throttle body down to 4".
http://www.mercurymarauder.net/gallery/showphoto.php/photo/14729 (http://www.mercurymarauder.net/forums/../gallery/showphoto.php/photo/14729)

Held up okay but was a little thinner than what I wanted. If you can find one for $13 go for it as I think this one was a little more expensive. It was about $20± if I remember right.
Blk Mamba
09-04-2009, 02:00 PM
That's it, did you build yours out of all spectre parts?
cougar9150
09-11-2009, 03:49 PM
Ya I bought all the pipe pieces and couplers from Jegs and Summit. I built the box myself out of some thin ABS, then redid it with some 1/8" or 3/16" ABS. I used Edge grip seal I got from McMaster Car to seal out the heat. IAT would stay around 3-5° over ambient temp when driving and then increase about 10-15° when at a light for a long time. Never got over 115° of all the times I logged with my Predator. It was all left in the old car because I could not open the hood after the accident.
NRAUD
09-11-2009, 05:18 PM
$13 is good. I got my Spectre 9791 from Checker online for $24.99


So does Spectre that is specifically made for the 4.6L oval throttle body P/N 9791. I used one on my first MM for the home made CAI I made. It was the exact dimensions of the throttle body down to 4".
http://www.mercurymarauder.net/gallery/showphoto.php/photo/14729 (http://www.mercurymarauder.net/forums/../gallery/showphoto.php/photo/14729)

Held up okay but was a little thinner than what I wanted. If you can find one for $13 go for it as I think this one was a little more expensive. It was about $20± if I remember right.