PDA

View Full Version : SRP Heel Plates



fastblackmerc
09-10-2009, 11:26 AM
Just finished painting and installing SRP's Marauder heel plates on my set on "show" floor mats.

Driver & Passenger
http://i167.photobucket.com/albums/u133/fastblackmerc/MM%20Mods/Hell%20Plate/DSCN0607.jpg

Drivers
http://i167.photobucket.com/albums/u133/fastblackmerc/MM%20Mods/Hell%20Plate/DSCN0606.jpg

Passenger
http://i167.photobucket.com/albums/u133/fastblackmerc/MM%20Mods/Hell%20Plate/DSCN0605.jpg

Drivers side in the car
http://i167.photobucket.com/albums/u133/fastblackmerc/MM%20Mods/Hell%20Plate/DSCN0603.jpg

Passenger's side in the car
http://i167.photobucket.com/albums/u133/fastblackmerc/MM%20Mods/Hell%20Plate/DSCN0597.jpg

TAKEDOWN
09-10-2009, 11:45 AM
Those are nice!

fastblackmerc
09-10-2009, 11:47 AM
Thanks! :beer:

Black bart
09-10-2009, 02:24 PM
They look great!

What tpy and size of mounting hardware did you use?

I have a set. am ready to install them in my MM this week end


thanks


fred

Hacklemerc
09-10-2009, 02:27 PM
Very sharp, I haven't pulled the trigger on a set of pedals or these yet... Very nice.

fastblackmerc
09-10-2009, 02:28 PM
They look great!

What tpy and size of mounting hardware did you use?

I have a set. am ready to install them in my MM this week end


thanks


fred

I used the hardware that came with the plates. After marking the positions, I used a hole punch to make holes so the shaft of the "T" nuts fit.

CRUZTAKER
09-10-2009, 07:24 PM
What finish did you choose, and how well is the match to your older pedals?

It appears as though you have the same pedals as I do, the one's Ladyhawk pioneered.

fastblackmerc
09-11-2009, 04:47 AM
What finish did you choose, and how well is the match to your older pedals?

It appears as though you have the same pedals as I do, the one's Ladyhawk pioneered.

Both the pedals and the heel guards are the machined finish. The pedal have about 3 or 4 years of use on them. The heel guards are newly installed and will never see any use.

MM03MOK
09-11-2009, 04:54 AM
Looks great, Jim! Thanks for sharing the photos! Very nice touch.

fastblackmerc
09-11-2009, 06:29 AM
Looks great, Jim! Thanks for sharing the photos! Very nice touch.

Thanks Mary!

Black bart
09-15-2009, 07:53 AM
I used the hardware that came with the plates. After marking the positions, I used a hole punch to make holes so the shaft of the "T" nuts fit.

Thanks for the info. did the same following your lead and am pleased with the results...then back to working on the wifes Durango!

Now stiff as a board!

fred :D