PDA

View Full Version : help me the ABS And BRAKE light


yryr999
11-03-2009, 07:10 AM
hello every one before two days ABS shutdown and the light is on
I go to workshop to do a test in the computer they can't the computer say the ABS no communication .. :confused:

what i do now :help: .. the BRAEK is bad and to strong:bigcry:

http://filestore.nimbuzz.com/eXaiLxEy
Marauderjack
11-03-2009, 04:08 PM
WHAT????:confused:
Hacklemerc
11-03-2009, 04:24 PM
what he said^^^^??
ntd
11-03-2009, 05:24 PM
Not positive but it sounds like your saying when you do a selftest on the abs system you get no communication? If thats the case get a wiring diagram check all powers and grounds to the abs module.
fastblackmerc
11-03-2009, 06:09 PM
Dude, learn to type and speak ENGLISH.... also use proper grammar.... it helps
yryr999
11-07-2009, 06:10 AM
i check all the faues and cabelis all is good
SC Cheesehead
11-07-2009, 06:19 AM
Here, I fixed it for you:

I checked all the fuses and the cables are all good.

Might be a sensor. Had a similar issue on my DTR.
yryr999
11-07-2009, 06:25 AM
did you say i have to check all the sensor ?? or what??
Phrog_gunner
11-07-2009, 06:28 AM
Dude, learn to type and speak ENGLISH.... also use proper grammar.... it helps

Isn't this one of the guys from Saudi? Cut him a little slack, maybe? I bet his English is better than your Arabic...:P
SC Cheesehead
11-07-2009, 06:29 AM
I had mine fixed under warranty, but as I recall they checked all the sensors, the left front was defective, and I also think there were some problems in the wiring harness.

You may have to take it to a dealer for a system diagostic if you can't track it down.
yryr999
11-07-2009, 06:34 AM
the proplam is when i check the system by the computer it can't becouse the ABS is no communication that word is moniter of the laptop ..
ntd
11-08-2009, 08:18 AM
If the abs module isn't communicating on a selftest and you have checked that all powers and grounds are good. Also check the high speed network(hs-can) this is the two wires used buy the modules to communicate. check them from the data link port to the abs module if those are good and power and ground is good you may have a faulty abs module.