PDA

View Full Version : New Eaton Swap Guy's



musclemerc
03-27-2010, 03:29 PM
I had a few EGR parts left over from making EGR adaptor's for the shorty header swaps and decided to make use of the left over hardware. These are the block off's for the EGR pipe on the DS header, all you have to do is make a block off for the upper intake and your done. I will give them to anyone who want's them (2 total). They have been pressure tested and water tested then painted with a satin black finish. You pay to ship!

ImpalaSlayer
03-27-2010, 04:08 PM
nice offer, i just cut the end off, pinched it shut them welded it. not the prettiest but it works

musclemerc
03-27-2010, 04:32 PM
That work's too Dave, I had just got my gas tank filled for my Mig and just wanted to weld up a little som.. something!

ImpalaSlayer
03-27-2010, 04:33 PM
That work's too Dave, I had just got my gas tank filled for my Mig and just wanted to weld up a little som.. something!

i love when welding goes right, kinda like paint. but when it goes wrong i wana throw it all in the garbage

musclemerc
03-27-2010, 04:41 PM
Very True! I was just priming up for the doubled up stock control arms... Remember those?

ImpalaSlayer
03-27-2010, 04:47 PM
cant say that i do

musclemerc
03-27-2010, 04:56 PM
Take two pair of the factory upper and lower control arms and remove the bushins and weld them together. Re-install the bushins and you got a strong set of upper and lower CA's. I have a DIY powdercoating kit so I will got the extra step and PC them. Control arms on the cheap!

ImpalaSlayer
03-27-2010, 04:59 PM
Take two pair of the factory upper and lower control arms and remove the bushins and weld them together. Re-install the bushins and you got a strong set of upper and lower CA's. I have a DIY powdercoating kit so I will got the extra step and PC them. Control arms on the cheap!

i have a PC setup also but havent finished my custom oven yet.

musclemerc
03-27-2010, 05:01 PM
Gotta love tools!

musclemerc
05-01-2010, 06:58 AM
Only 1 left... Anyone else?

SC Cheesehead
05-01-2010, 07:24 AM
Gotta love tools!

If it doesn't say "Binford", someone else made it. - Tim Allen, Tooltime