Is there anything else I can do for the EATC?

[68Camaro]

So i switched out all the o-rings, made sure they were all on well. Cleaned all the parts, chased down all the vacuum lines to the best of my ability...all plugged in. Everything on the EATC works, floor, defrost, flr/def...everything but the vent. Pushing AC directs air to the floor. I know i did something right with the o-rings cause I'm getting much more air coming out now, and the floor did not work prior. Is there any "door" or mechanism that I can spray with some compressed air? Any chance that something might just be stuck?

[fastblackmerc]

So i switched out all the o-rings, made sure they were all on well. Cleaned all the parts, chased down all the vacuum lines to the best of my ability...all plugged in. Everything on the EATC works, floor, defrost, flr/def...everything but the vent. Pushing AC directs air to the floor. I know i did something right with the o-rings cause I'm getting much more air coming out now, and the floor did not work prior. Is there any "door" or mechanism that I can spray with some compressed air? Any chance that something might just be stuck?

Make sure the o-rings are installed correctly.

Check the electrical connection (red connector) inside the EATC. You might have not installed it on the pins correctly.

[Hitmani90]

I am having the same problem, Did you ever get this issue resolved? could use some advice. i fixed my EATC to the best of my knowledge : /