14 hours later....

[MercOut]

Well, yesterday me and a friend began the Kooks headers & full stainless steel exhaust swap at 8am. The worst part of it all was not having a lift but I can't complain because it was a free install :D(gotta love friends). The studs and nuts were a real PITA to take off; that took the longest, so many different angles you had to take to get these MF's off :mad2:

But 14 hours(10pm if you can't count), we finally finished up to the Magnaflows. Couldn't go any further because the rest needs to be welded on. Love the sound and the extra HP, can't wait to test it out after work today:banana2:. Next step is to get my over axle pipes and tips welded back on.

MY total cost vs performance: Well worth it!!! Props to Natehawk:beer:

Here are a few pics:

The mastermind behind all my mods
http://i28.photobucket.com/albums/c241/lilmalimal/th_f2635dfd.jpg (http://s28.photobucket.com/albums/c241/lilmalimal/?action=view&current=f2635dfd.jpg)

Didn't have a mask for shaving the bolts so a Helmet will do just fine lol
http://i28.photobucket.com/albums/c241/lilmalimal/th_c03a9125.jpg (http://s28.photobucket.com/albums/c241/lilmalimal/?action=view&current=c03a9125.jpg)

Our "Lift"
http://i28.photobucket.com/albums/c241/lilmalimal/th_cb173f44.jpg (http://s28.photobucket.com/albums/c241/lilmalimal/?action=view&current=cb173f44.jpg)

[ctrlraven]

Don't forget to get a dyno tune asap and don't go WOT or high into the rpms until you get your air/fuel checked and corrected.

[bawazir]

I bet the passenger side headers is pain in the ass to do ?