8 bolt flexplate

[tjl006]

Looking for an eight bolt flexplate ford#m6375h46 or performance automatic sfi flexplate 8bolt pa26478-8 or an equivalent flexplate the could be used to put a cobra motor or aluminator into a marauder.

[ImpalaSlayer]

Looking for an eight bolt flexplate ford#m6375h46 or performance automatic sfi flexplate 8bolt pa26478-8 or an equivalent flexplate the could be used to put a cobra motor or aluminator into a marauder.

go to napa ask for a flex plate from a 99 f250 with the 5.4, should yield you the correct part. what ya got going on up there man?

[tjl006]

Got problems, grit left in my intake from the powdercoater has left me with a 500 pound paper weight.

[ImpalaSlayer]

Got problems, grit left in my intake from the powdercoater has left me with a 500 pound paper weight.

dude you gotta be ****ing kidding me! that blows man. real big. did it destroy your fresh heads too?

[dohc324ci]

Lonnie over Blue Oval Chips is where I picked up mine (FRPP M-6375-H46). At that time he was one of the only vendors to carry it....I search everywhere.

[tjl006]

When the motor comes back out I got to check the valves but i assume the guides and stems are scored. Apparently beating the intake into the sidewalk multiple times, running a leafblower through it and using a garden hose wasnt enough to remove the baked in grit. The intake inlets felt like the beach.

[ImpalaSlayer]

thats insane. got a line on a short block?

[ntd]

Man that suck I know you've been trying hard to get your engine together and now this.

[ImpalaSlayer]

hey Tom, this may be on interest.

http://www.svtperformance.com/forums/terminator-parts-buy-sell-242/702071-fs-03-cobra-longblock-one-bad-piston.html

[Speed]

hey Tom, this may be on interest.

http://www.svtperformance.com/forums/terminator-parts-buy-sell-242/702071-fs-03-cobra-longblock-one-bad-piston.html


or this one I've been watching it for awhile


http://www.svtperformance.com/forums/terminator-parts-buy-sell-242/604063-parting-out-entire-car-03-2-6-kenne-bell-cobra-dsg-lots-mods.html

[musclemerc]

Man I know what a hard time you've had with the MM since the Eaton. If you need some help PM me, it would be my pleasure.

[dohc324ci]

Man good luck with all that man. Sometimes I wonder about this hobby...Ive dump so much $$$ into mine it aint even funny.

My 2 cents go with an aluminator LB I was quoted $5200 shipped for an NA Aluminator LB.

[ImpalaSlayer]

or this one I've been watching it for awhile


http://www.svtperformance.com/forums/terminator-parts-buy-sell-242/604063-parting-out-entire-car-03-2-6-kenne-bell-cobra-dsg-lots-mods.html

thats not bad!

[tjl006]

Thanks for the words guys:beer:. Right now i am strongly considering the NA aluminator got a quote from tousley $6100 shipped to the door with a twelve month warranty, asked them about the 5200 quote dohc they said it must of been a mistake, Mike and steve at tousley are good guys to deal with though. Not really looking to go with a shortblock or to deal with machine shops the more i deal with shops the sicker I get, wether it be machine shops,powdercoaters or tuners. Do it yourself with oem parts that seems for the most part(of course there are exceptions) the best way to go.

[musclemerc]

Can't go wrong with Tousley, those guys are great, did you ask for the discount for SVTP members?

[tjl006]

Can't go wrong with Tousley, those guys are great, did you ask for the discount for SVTP members?

Yeah the 6100 is the discount price.

[dohc324ci]

The quote I got was the NA version $5200; they quoted you the SC version right? That was the price they quoted me as well...$6100 shipped IIRC.

[ImpalaSlayer]

after all these damn storys, im wondering if that wouldnt be the best way to go.

[tjl006]

The quote I got was the NA version $5200; they quoted you the SC version right? That was the price they quoted me as well...$6100 shipped IIRC.
The $6100 is for the NA version. I mentioned your price they said they must of made a mistake when they quoted you:confused:.

[dohc324ci]

after all these damn storys, im wondering if that wouldnt be the best way to go.

Certainly cant go wrong with FRPP Aluminator NA LB is all forged and 10:1 to boot!

[dohc324ci]

The $6100 is for the NA version. I mentioned your price they said they must of made a mistake when they quoted you:confused:.

Ok, well I should have said this was last year around this time....usually cost plus 10% if you mention a certain site.

Anyhow looks like the new Coyote 5.0 create is going to be available...M-6007-M5L

[Spectragod]

Ok, well I should have said this was last year around this time....usually cost plus 10% if you mention a certain site.

Anyhow looks like the new Coyote 5.0 create is going to be available...M-6007-M5L

Been exploring my options, looks like an Aluminator will be in my future, I saw the Coyote motors on Fords page, if I thought I could make it work, without a ton of mods, I would probably consider it.

Ford does say that the warranty on their motors is only valid if a Dealer installs them.

Sorry for the Hi-jack.

[tjl006]

Been exploring my options, looks like an Aluminator will be in my future, I saw the Coyote motors on Fords page, if I thought I could make it work, without a ton of mods, I would probably consider it.

Ford does say that the warranty on their motors is only valid if a Dealer installs them.

Sorry for the Hi-jack.

Here is frpp warranty page. says nothing about dealer installation http://www.fordracingparts.com/warranty/limited_warranty_crateengine.p df. I would agree though it would probably be easier to get warranty work done if it was installed at a dealer.

[Spectragod]

Your correct, my fault.... I breezed through that warranty stuff, I just re-read it, I highlighted in red what I was referring to, it doesn't look like they were referring to the Aluminator.

The New Limited Warranty Program
All Ford Racing Parts are aftermarket parts. Ford Racing Parts are not Genuine Ford Parts or Accessories. Therefore, they may not be used in any application that requires the use of Genuine Ford Parts or Accessories.
Ford Racing Performance Parts are sold "as is" with no warranty (http://www.fordracingparts.com/warranty/standard_warranty.pdf). A Limited Warranty is available for some select parts and will be denoted by the following logo... http://www.fordracingparts.com/images/warranty/warranty-icon-small-t.gif
1) Crate Engines (http://www.fordracingparts.com/warranty/limited_warranty_crateengine.p df) http://www.fordracingparts.com/images/warranty/warranty-icon-tiny-t.gif
Ford Racing Performance Parts warrants the original retail purchaser for 12 months or 12,000 miles on our Performance Crate Engines.

2) FR1 & FR3 Power Packs for the 2005 - 2010 Mustangs and Shelby GT500 (http://www.fordracingparts.com/warranty/FORD_RACING_LIMITED_WARRANTY_2 010.pdf) http://www.fordracingparts.com/images/warranty/warranty-icon-tiny-t.gif

The warranty will cover parts and labor to replace defective components on Ford Dealer installed parts only.

A 3 year / 36,000 mile warranty is applicable if installed at the time of new vehicle delivery
A 12 month / 12,000 mile warranty is in effect if installed after the date of vehicle delivery but prior to expiration of 3 years / 36,000 mile vehicle warranty

3) Select FR SuperPacks for 2005 - 2010 Mustangs and 2007 - 2010 Shelby GT500 (http://www.fordracingparts.com/warranty/FORD_RACING_LIMITED_WARRANTY_2 010.pdf)

The warranty will cover parts and labor to replace defective components on Ford Dealer installed parts only.

A 1 year / 12,000 mile warranty is applicable when installed by an Authorized Dealer ( Ford, Lincoln Mercury or Shelby Automotive) prior to the vehicle reaching either 36 months or 36,000 miles (whichever occurs first).
View Ford Racing Limited Warranty for details
Look for the http://www.fordracingparts.com/images/warranty/warranty-icon-t.gif (http://www.fordracingparts.com/announcements/news47.asp) "logo" for applicable parts, or view our warrantied parts (http://www.fordracingparts.com/warranty/warrantyparts.asp)

[tjl006]

No problem:beer:. And what I herad from tousley is if you buy one of there reman engines and place it into the correct vehicle (marauder motor in a marauder) you get a 3yr 100,000 mile warranty.

[dohc324ci]

you are correct^^

I almost went this route $4200 for reman.