ABS light on.....

[Midnight]

Well.... driving in the rain the other day, my ABS light comes on....

i just had all bearings changed, front hubs and rear axles and bearings...

ran about 500 miles on them. and now the ABS light.

Any ideas? i tried unplugging and plugging back in the fronts (i dont know exactly where the rear connectors are, im sure i could track it down)

reset the ECM with my SCT, and still not off

it turned off ONCE, then has been on ever since.

i am taking it to my quite trustworthy mechanic, but was seeing if anyone had this issue, and could possibly save me time.

[Midnight]

also, my passenger rear brake disk has not completely seated on the rotor.... been almost 300 miles since i replaced the brakes, rotors and pads....

maybe that has something to do with it. lol

[4play]

you need a different scanner to scan the abs, you could try to clean the wheel sensors, but if you want to save time and hassle just go get it scanned

[W4LTD]

Place a piece of black electrical tape over the ABS light on your gauge cluster.

[Marauderman]

Check again the rears-take off the tires on a jack or stand--My screw holding in my ABS sensor had come loose and even the magnet part that is an added protection didn't hold--there it was just hanging bouncing against the tire--check them both--screwed them back in --problem went away--------

Maybe it happen when you had your wheel work done and it vibrated loose from incomplete re-install----worth checking anyway-

[Krytin]

Did you have the tires rotated?
If the shop rotated front to rear/rear to front the tires are different sizes and will throw an abs light!

[Midnight]

They did rotate the fronts to the rears, but i am running the same size tire all around.

the extended holiday really pushed my repair back.

but, is most likely due to a shotty reinstall, from when my bearings were completed.

[4play]

Well if you have traction control you cant run all same size tires