PDA

View Full Version : Parts questions


ctrlraven
08-24-2010, 02:59 PM
Didn't want to post it on your monthly special thread.

Forced Lube Kits with Stainless steel lines.
^What exactly does this entail?

Dynotech Drive shafts 4" 6065 T5 aluminum and 3 1/2"
^What are the benefit differences between having a 3.5" and a 4"?

Thanks.
Dennis Reinhart
08-25-2010, 10:18 AM
The forced lube kit feeds transmission fluid directly on the rear tail shaft bushing, insuring it will never burn out, the only way it gets fluid now is by splash effect when you launch the car, and at sustained high speeds very Little if any fluid gets back there, I just sold my last set of SS lines but have five on order.
massacre
08-25-2010, 11:52 AM
^^^ from what I have heard, this is only an issue with RAR's over 3:55.....?
Might want to get a kit that comes with a new tailshaft and bushing, just easier IMHO.

4" driveshaft is beefier, but not much heavier.
ctrlraven
08-25-2010, 12:50 PM
The forced lube kit feeds transmission fluid directly on the rear tail shaft bushing, insuring it will never burn out, the only way it gets fluid now is by splash effect when you launch the car, and at sustained high speeds very Little if any fluid gets back there, I just sold my last set of SS lines but have five on order.
Thank you for explaining it, let me know when your next order of them comes in.


^^^ from what I have heard, this is only an issue with RAR's over 3:55.....?
Might want to get a kit that comes with a new tailshaft and bushing, just easier IMHO.

4" driveshaft is beefier, but not much heavier.
Thanks. Just trying to figure out which would be better for my car, it's driven mostly on the roads and will see the track maybe 2 or 3 times a year if that. I had 4.10s installed the other month ago and SmokdMercRauder (who installed them) noticed one of the weights on my driveshaft is starting to peel off the driveshaft.
ctrlraven
09-13-2010, 11:29 AM
Dennis do you have any of the Forced Lube Kits with Stainless steel lines kits in stock now?
Dennis Reinhart
09-13-2010, 12:21 PM
Dennis do you have any of the Forced Lube Kits with Stainless steel lines kits in stock now?


Yes just give me a call and I hod no luck with the other cars brake lines, I am having Marauders made
ctrlraven
09-14-2010, 11:35 AM
You don't happen to have a picture of what the kit looks like and installed do you?