Eaton rebuild??

[clintons4]

I am searching for a ported eaton and stumbled across this:

"So i just installed a new kenne bell on my cobra, and i have a ported eaton for sale. The blower has a stage 5+ steigmire port. Blower has 15000 miles on it since new. So here is the bad part, The blowers rotors kinda got in sword fight... Its not horrible, but if you intend to use the rotors and the front drive from this blower i highly recommend a rebuild I am asking 400 for the blower. If you have a stock blower you can just pull the guts out of yours and throw it into this ones case. this port cost me 700+ dollars when i did it. In addition to the blower i have a stock TB and elbow (could be ported for 200 bucks) If you buy the blower i will throw those in for an extra $50 if interested. Send me a PM if you are interested. I will consider any offers"

I can buy this above for $350. What does it cost to rebuild one of these units?

[SC Cheesehead]

I am searching for a ported eaton and stumbled across this:

"So i just installed a new kenne bell on my cobra, and i have a ported eaton for sale. The blower has a stage 5+ steigmire port. Blower has 15000 miles on it since new. So here is the bad part, The blowers rotors kinda got in sword fight... Its not horrible, but if you intend to use the rotors and the front drive from this blower i highly recommend a rebuild I am asking 400 for the blower. If you have a stock blower you can just pull the guts out of yours and throw it into this ones case. this port cost me 700+ dollars when i did it. In addition to the blower i have a stock TB and elbow (could be ported for 200 bucks) If you buy the blower i will throw those in for an extra $50 if interested. Send me a PM if you are interested. I will consider any offers"

I can buy this above for $350. What does it cost to rebuild one of these units?

IMO, if you're planning an Eaton swap on an otherwise stock MM motor, just pick up a used Eaton off the Internet. Going price is usually around $300, a bit higher if it comes with the pulley, a bit less if it doesn't include the plenum (i.e. "elbow").

[thathotrodlincn]

I think Eaton, and Trilogy superchargers are both manufactured by Magnuson. They have a rebuils program. Contact them for rebuild information.

[musclemerc]

Good Luck with the sale!

[Georges93LX]

I've got a ported and a stock Eaton for sale. If your interested PM me.

[RF Overlord]

I think Eaton, and Trilogy superchargers are both manufactured by Magnuson. It's the other way 'round. Eaton is the manufacturer while Magnuson Products is one of 4 sales and service partners, along with Edelbrock and Roush in the US and Harrop in Australia.