Bradley G
10-09-2010, 10:06 AM
The window switch was intermittent (up only) on the drivers window so I took it apart and cleaned the contacts and bent the rocker enough to make good contact.
I did a smoke test before installing the switch back into its chassis and plugged the harness in wrong and literally smoked something on the circut board.
The results from my error; The drivers window would go up but would not go down.
Anybody that wants it pay the shipping and I'll send it to you.
I did notice when I took the switch apart that the toggle part had plungers spring loaded that one side was worn from working the button too hard.
lots of pieces inside the switch to go bad if you want a DIYS project.
I did a smoke test before installing the switch back into its chassis and plugged the harness in wrong and literally smoked something on the circut board.
The results from my error; The drivers window would go up but would not go down.
Anybody that wants it pay the shipping and I'll send it to you.
I did notice when I took the switch apart that the toggle part had plungers spring loaded that one side was worn from working the button too hard.
lots of pieces inside the switch to go bad if you want a DIYS project.