Need exhaust manifold and header pictures

[Youngblood]

I'm about to start porting my new fr500 heads for the new motor I'm building. I'm going to port match the exhaust to the gaskets because the fr500 ports are very small. I just want to make sure I dont open them up too much. For now I'll be runnig stock manifolds then headers in a few months

What I need is a picture of a stock mm exhaust manifold and marauder headers with a gasket applied so I can see how close the manifold ports are to the Actual gasket holes. Depending on how they match up I may not have to open the exhaust up as much depending on how the gaskets match to the headers and manifolds

[massacre]

I may have an extra set of exhaust manifold gaskets. Does that help you at all?
free......

[musclemerc]

I just pulled an engine and matched the gaskets to stock manifolds. They are already pretty close to the gasket opening.

[Youngblood]

I may have an extra set of exhaust manifold gaskets. Does that help you at all?
free......

I actually just got new gaskets from my cobra headset. That's what I'll be using to port match the heads. Thank you very much though I really do apreciate the offer.

[Youngblood]

Thank you musclemerc. I figured they have to be close. I've done other applications where the gasket opening were much larger then the manifold ports. I'll prob go all out and just open the heads up completely to the gaskets. My problem is my manifolds are still on my car and it's my dd. Next motor is on a stand awaiting the heads and more goodies before I swap it out for the old motor