PDA

View Full Version : Drive Shaft loop


Vortech347
08-15-2011, 01:37 PM
What drive shaft loop do you guys run in your MM's?
MOTOWN
08-15-2011, 01:46 PM
I have a metco i have yet to install
Mr. Man
08-15-2011, 01:49 PM
Metco is popular and I believe is easy to install.
Vortech347
08-15-2011, 01:53 PM
Is it specific to the MM's?

I'm thinking about just getting the one from Summit for the stangs.
MOTOWN
08-15-2011, 01:56 PM
Is it specific to the MM's?

I'm thinking about just getting the one from Summit for the stangs.

Yes it is! you cant go wrong with metco!:banana2:
ctrlraven
08-15-2011, 02:04 PM
If your underside is rusted any throw some PB Blaster on the seat bracket bolts under the car.
Vortech347
08-15-2011, 02:05 PM
Oh nice, no drilling but gota remove the driveshaft, well. It'll have to come out anyway if I swap it.

Nice. Thanks guys.
DOOM
08-15-2011, 02:36 PM
I'll be going with the metco also.
RacerX
08-15-2011, 02:49 PM
Hillbilly driveshaft loop! :D

http://i540.photobucket.com/albums/gg360/skeeveman/Chevelle/driveshaft%20loop/IMG_2860Large.jpg
fastblackmerc
08-15-2011, 03:09 PM
Metco is the way to go!
Vortech347
08-15-2011, 05:10 PM
I have a welder and would much rather go hillbilly route but I don't have the materials or skills to properly bend it.

Good job.
Bradley G
08-17-2011, 06:13 AM
I had a friend put the Metco on , I hope it never is needed!:burnout:
SMOKE
08-17-2011, 10:36 AM
Metco....driveshaft is a breeze to drop as long as you are high enough off the ground (and if you've got air tools unlike me I'm sure its even faster)....

I gotta say though, under my car is clean and rust but free learned the PB Blast lesson after shearing/swearing/drilling/drilling/ez out/drilling/swearing
my way through the passenger side seat bolt....DS didn't want to come out either but a little heat changed that....other than that a quick/safe mod.

Best,
Jonathan
napolitano
08-17-2011, 02:07 PM
I went with the one Reinhart sells.
ImpalaSlayer
08-17-2011, 04:15 PM
I have a welder and would much rather go hillbilly route but I don't have the materials or skills to properly bend it.

Good job.

then get a short piece of pipe. i put the metco on mine and it seemed pretty wimpy personally.
Bradley G
08-17-2011, 04:29 PM
I felt like it was well constructed , really heavy too!
then get a short piece of pipe. i put the metco on mine and it seemed pretty wimpy personally.
justbob
08-17-2011, 06:42 PM
Here's mine. Not sure of brand or what year mustang. I figure there is plenty enough here to make it fit, plus it is fully adjustable. $25 shipped was more than fair.

As far as a homemade, go to a plumbing supply house and get a small piece of scrap 6" ductile iron water service pipe. You will NOT break that even if you had 12 driveshafts...

Sent from my Ally using Tapatalk