PDA

View Full Version : HVAC???...what gives



biggeorge04
09-20-2011, 08:14 AM
New to board...AC blows cold through the defroster..cant change temp OR position of air flo..and to top it off my blower fan QUIT!!!!!...is there a self diagnostic i can do or is this dealer only fix???:confused::confused:

MM03MOK
09-20-2011, 08:17 AM
http://www.mercurymarauder.net/forums/showthread.php?t=36922

tbone
09-20-2011, 08:50 AM
You need a new blower control module for the fan.

http://www.mercurymarauder.net/forums/showthread.php?t=48707&highlight=blower+control+modul e

biggeorge04
09-20-2011, 11:33 AM
do it myself or dealer fix??...expensive?????...thank s for help!!!

fastblackmerc
09-20-2011, 12:37 PM
do it myself or dealer fix??...expensive?????...thank s for help!!!

The BCM is around$ 75.00, not hard to do if you have small hands and patience.

You can fix the EATC you self too, just need the right o-rings. Or you can send it to me for repair.

biggeorge04
09-21-2011, 07:30 AM
thanks guys for quick reply!!...i tapped BCM with a screwdriver.. its working again...but now it seems its blowing hot air and the temp wont change even when i put ac on!!!

tbone
09-21-2011, 08:32 AM
BCM only controls blower. Refer to post #2.

It might be your blend door if the temp won't change. Pray that it's not.

biggeorge04
09-21-2011, 09:26 AM
it never made the tapping noise (door/vent trying to open or close) until ___after i ran the diagnoistics test...before it was quiet and even though still blowing cold out the defrost..with that being said is there any way to clear a code or something to at least get annoying noise to stop and get it to were it was before diagnostic test was done??..seems i made a bad prob even worse:confused:..thx for input

fastblackmerc
09-21-2011, 10:05 AM
thanks guys for quick reply!!...i tapped BCM with a screwdriver.. its working again...but now it seems its blowing hot air and the temp wont change even when i put ac on!!!

Sounds like the blend door motor is bad.

biggeorge04
09-21-2011, 10:23 AM
would that also be reason for not being able to change temp??..if so..expensive fix???..i dont mind if it comes out of defrost for now i just want it to be cold not hot if possible...any way to stop the door tapping noise behind radio until i get fixed(annoying)...can i take it to a dealer and hav them clear it??..most appreciated!!

SC Cheesehead
09-21-2011, 10:50 AM
would that also be reason for not being able to change temp??..if so..expensive fix???..i dont mind if it comes out of defrost for now i just want it to be cold not hot if possible...any way to stop the door tapping noise behind radio until i get fixed(annoying)...can i take it to a dealer and hav them clear it??..most appreciated!!


http://www.mercurymarauder.net/forums/showthread.php?t=69180&highlight=blend+door