Front end parts diagram?

[GetMeMyStogie]

Does anyone have a diagram showing how the soft front-end parts go together? I'm referring to the soft rubber-like panels that cover the gap between the lower lip of the front bumper cover and the wheel opening - the parts that have the velcro flaps in them for accessing the foglights.

My front bumper was repaired a while ago, and it looks like the guys who put it back together did it wrong - I can't open the velcro flap on the pass. side to change the fog bulb!


P.S. I linked some documents I got from Ford, so you don't have to go searching through the thread.

[fastblackmerc]

Does anyone have a diagram showing how the soft front-end parts go together? I'm referring to the soft rubber-like panels that cover the gap between the lower lip of the front bumper cover and the wheel opening - the parts that have the velcro flaps in them for accessing the foglights.

My front bumper was repaired a while ago, and it looks like the guys who put it back together did it wrong - I can't open the velcro flap on the pass. side to change the fog bulb!

The fuzzy side of the velcro is on the flap, sticky side of the velcro is on the stationary side.

Maybe they glued it down?

[Marauderjack]

I pulled mine off back in '05 and threw them away!!:D

[Baconbit]

Velcro??? Heck here in WV we use Duct Tape! It's WV chrome!(Doom would love it!):banana:

[kariamack]

This might help
http://www.gdmjoe.com/marauder/docum...rpartslist.pdf (http://www.gdmjoe.com/marauder/documents/2003grandmarquis-marauderpartslist.pdf)

[GetMeMyStogie]

The fuzzy side of the velcro is on the flap, sticky side of the velcro is on the stationary side.

Maybe they glued it down?

No, they installed an air deflector of sorts inside, right over top of where you would normally shove the flap.

[GetMeMyStogie]

This might help
http://www.gdmjoe.com/marauder/docum...rpartslist.pdf (http://www.gdmjoe.com/marauder/documents/2003grandmarquis-marauderpartslist.pdf)

Thanks so much. It's close, but no cigar :depress:
This shows generally what's there, and it shows the sheet metal parts, but none of the soft parts between the bumper cover and wheel well/housing/lining. This is also a great source for part numbers :)

[GetMeMyStogie]

I eventually went to my nearest Ford dealership, where I usually buy parts if I'm looking for OE. I asked the counter guy, who's been there forever, if he could help me out with some parts diagrams. He said "Sure!". And I got what I was looking for :)

I figured I'd scan it and post it up here, in case anybody else is looking.


http://www.mercurymarauder.net/forums/picture.php?albumid=43&pictureid=1136

Looks like the pic was resized a bit - I've attached a pdf to the top post

I got a few others that I added to an album: http://www.mercurymarauder.net/forums/album.php?albumid=43

[Juice]

Nice grab!

If I could make a small request, could you attach the PDF for the header panel one? I'm actually about to take all that out for my grille/header panel replacement.

[GetMeMyStogie]

If it's not too late, check the first post. I added pdf of all of the printouts I got.