Megs 4" Marauder Exhaust Tips - Available

[coneeng]

I thought we had sold out but I just found a few sets when we were moving some inventory in the warehouse. Give a call soon - I had been telling everyone we were sold out.

Specs: ST640, 4" tip, rolled edge 304SS bright polish, 26" long, 15 degree angle cut, 2.50" inlet (not the OE 2.25"), resonator delete. $120 per tip plus shipping (continental US UPS Ground usually $20-$25).

Rich
Cone Engineering / Megs
714-828-3580
Rich@coneeng.com

[coneeng]

Down to the last 3 sets! Call soon.

[71cyclone]

Down to the last 3 sets! Call soon.
Mine came in and are installed// THANK:banana2:Z AGAIN

[coneeng]

Hello Everyone,

We are completely sold out of the 4" Marauder tip at this time.

Around September/October I will start putting out feelers to see if there is enough demand for a new production run of either the 4" or 3.50" tips. I would expect that as before there will be a pre-buy special for the forum.

I recommend subscribing to the orginal thread http://www.mercurymarauder.net/forums/showthread.php?t=73496&page=13 as I will update a post here and link to the new thread when we get ready to announce a new run.